Discussions > Instrument Design, Construction and Repair
Hohner Backplate Screws
Vallenato831:
Anyone know what size are those micro screws that hold the back plates in place? I'm talking on the Corona II and III models. So tiny that I'm missing 3 of them. :o
MarioP:
I easily replace those with regular half inch nails ... just safely take this remaining pin with you to the hardware store and youll find a variety if not look up ebay hohner pins there a few folks selling those.
Let me know its 5 AM here but can get the meaduring tape off my van later on to get exact measures.
John MacKenzie (Cugiok):
I managed to buy some tiny brass screws from a model shop over here in the UK. I suggest you try that path.
SJ
triskel:
--- Quote from: Vallenato831 on October 07, 2015, 08:22:36 PM ---Anyone know what size are those micro screws that hold the back plates in place? I'm talking on the Corona II and III models. So tiny that I'm missing 3 of them. :o
--- End quote ---
I don't know the size because we don't play Coronas here, but I'd find it by measuring the length and diameter of them with my digital calipers. Once you have the size, you should be able to track some down on the internet...
Theo:
Are they wood screws or machine screws?
Navigation
[0] Message Index
[#] Next page
Go to full version