Discussions > Instrument Design, Construction and Repair

Removing the Bass End from a Modell 1 Erika

(1/3) > >>

baz parkes:
What it says on the tin, really

I need to get at the chord mechanism on my Bb/Eb...bit of a tumble (it not me...) and one of the bass buttons has broken and jammed.

Any advice, other than be really, really careful ?

Ta

Theo:
There should be a hole near each end of the bass strap. This is to give screwdriver access to the two screws that hold the ends on.  If you can't find the screws that way just take off the strap and remove the bass cover plate and you should see the two large round screw heads.

baz parkes:

--- Quote from: Theo on May 15, 2017, 03:03:39 PM ---There should be a hole near each end of the bass strap. This is to give screwdriver access to the two screws that hold the ends on.  If you can't find the screws that way just take off the strap and remove the bass cover plate and you should see the two large round screw heads.

--- End quote ---

Thanks Theo...just realised it's a Club, not an Erika.

Should the process be the same?

tom f:
Thanks Theo.  Always wondered what those holes were for.

Theo:

--- Quote from: baz parkes on May 15, 2017, 03:43:48 PM ---

Thanks Theo...just realised it's a Club, not an Erika.

Should the process be the same?

--- End quote ---

Just take a look and see!

Navigation

[0] Message Index

[#] Next page