Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: windybutton on June 07, 2013, 09:49:06 AM
-
Hi All
I've searched the forum but I'm still unsure how to stick back
The celluloid that's been lifting on the edges of the treble side.it almost looks like
It's shrunk
Should I suspend part in a closed bucket above water acetate mix or paint
The solution on the area to try and stretch back to place?
Any help much appreciated
Best regards
Roy
-
Please post a photo so we can see the problem.
-
Here it is
-
Here is another angle
This is a restore project from ebay so I'm not sure
How it became like this
The name of the box is Firotti
Thanks
Roy
-
I don't think you can do much more than to stick down the lifted edges. The usual method of softening the celluloid is to soak it in a 1:1 mix of acetone and water till it gets to the condition of soft rubber, then stretch it to fit the surface. The only way I could imagine doing that would be to remove the entire sheet, stretch and re-apply, but you really need to have a much bigger sheet so you have something to get hold of to do the stretching. I suppose the ultimate method would be to strip off all the celluloid and re-cover with new.
-
I have had good luck heating the celluloid with a heat gun on low. It gets flexible quite suddenly at a bit above 250 or so. Have a smooth block of wood handy to press down the celluloid you have softened.
You need to work fast once the celluloid is hot and soft as it cools quickly. Work small areas at a time. You can go back and do it again if you don't get it right.
Use contact cement to stick it down after ,working it under with a blade. Any glue with acetone in it will cause it to get weird and wrinkle.
Use matching nail polish to fill in edges or gaps, do only one application a day ,or you will find bubbles when you sand or file it out.
The heat gun method is what I use to flatten warped celluloid grills of old instruments. WARNING if while heating you get a strong smell of camphor it is TOO HOT, it will soon catch on fire! have a spray bottle and a wet rag at hand as a safety precaution.
-
Thanks for all advice
mel net is such a great resource
Cheers
Roy