Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: deltasalmon on July 27, 2013, 03:44:41 PM
-
I posted this before but I recently purchased a new C#/D melodeon and this is the base layout that it came with:
(top of instrument)
outside inside
chord G/C F#/B
bass G/C F#/B
chord D/G A/E
bass D/G A/E
As I started playing more tunes with basses as well as melody I decided that I did not like this layout and wanted to change it to match the more common "standard" layout or the Jackie Daly layout as talked about here (http://forum.melodeon.net/index.php?topic=12161.0). So yesterday I did some work on it.
To match the Jackie Daly layout the F#/B bass was good as it is. The A/E was the right bass but in the wrong position so the first thing I did was to switch the reeds from A/E to G/C and vice versa. Next was the more important change. I didn't like having the D/G bass and would much prefer the D/A bass that would allow me to play along the D row as if it were a 1-row and have the bass to match. I had new hohner reed blocks and reeds for the bass side of a GCF accordion in my basement (I ordered them hoping the blocks would fit a reedless three row accordion I have but they didn't so they had been sitting unused). The GCF bass had a A/D pair so I took them out and spun them around and put them instead of the D/G bass on my C#/D. After all the reeds were installed, waxed in and tested to make sure I had them all where they should be I was left with this:
(top of instrument)
outside inside
chord A/E F#/B
bass A/E F#/B
chord D/A G/C
bass D/G G/C
Not quite the Jackie Daly layout but I'm getting closer. You might have noticed that the bottom-outside pair is D/A for the chord and D/G for the bass. Unfortunately this is not a typo. The chord reeds from the Hohner block fit in no problem but when I took out the bass reeds I noticed the Hohner reeds were much wider than the ones in my Weltmeister and would not fit.
Is it possible to buy just two reeds for the D/A bass without having to buy a whole set?
The dimensions of the reeds that I need are: 2" x â…" x â…›" and 2¼" x ¾" x ¼"
I didn't have a metric ruler but google tells me these are about 51mm x 16mm x 3mm and 57mm x 19mm x 6mm