Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Billy Cutlip on November 19, 2013, 11:24:49 PM

Title: Happy accidents in the wax room
Post by: Billy Cutlip on November 19, 2013, 11:24:49 PM
Wax should probably be sold with a label that says "Do not put your bass reed plates back in after drinking high gravity ales," because I put 'em in 1-4-2-3 instead of 1-2-3-4. I do things like this sometimes, like trying to do a neck reset with a jackknife on an old parlor guitar after an especially crazy party. I fully understand the risks; don't try this at home, kids.

The thing is, some of those wrong notes are just beautiful, and make me think about adding some buttons and reeds and so forth. Big words for a neophyte, but oh, those harmonies...
Title: Re: Happy accidents in the wax room
Post by: Christopher K. on November 20, 2013, 12:04:53 AM
An admirable mistake, sir! All the more so for confessing publicly. (:)
Title: Re: Happy accidents in the wax room
Post by: Kimric Smythe on November 20, 2013, 08:16:46 AM
You discovered the lost chord!
Title: Re: Happy accidents in the wax room
Post by: EastAnglianTed on November 20, 2013, 09:54:02 AM
Who knows, may be a whole new breakthrough system for the box. I suggest more ale is needed  >:E  (:)
Title: Re: Happy accidents in the wax room
Post by: Rog on November 20, 2013, 07:00:02 PM
Or accidentally knocking a reed block onto the floor with elbow and having to rewax the plates that have popped out..
Title: Re: Happy accidents in the wax room
Post by: Theo on November 20, 2013, 07:15:11 PM
Knowingly my own ability to get reeds on the wrong place I always tack the reeds in place first with a couple of spots of wax, put the blocks in the instrument and check every button, and only then do the full wax treatment.
Title: Re: Happy accidents in the wax room
Post by: Lester on November 20, 2013, 07:20:40 PM
Knowingly my own ability to get reeds on the wrong place I always tack the reeds in place first with a couple of spots of wax, put the blocks in the instrument and check every button, and only then do the full wax treatment.

Thought it was just me  ;)
Title: Re: Happy accidents in the wax room
Post by: deltasalmon on November 20, 2013, 07:26:35 PM
Not a waxing issue but my first idea of how to re-tune a reed:

I knew that mass had something to do with frequency in which the reed vibrates. I wanted to raise the pitch of a reed from F to F# so without doing any research I pulled out my wire cutters and clipped off a bit from end of the reed. Afterwards it surprisingly did still play (though I'm sure it took much more air) but I started to wonder how I could lower the pitch of another reed...

Thankfully it was only a chanson (no offense Nick, et al.) that I was attempting to re-tune.
SimplePortal 2.3.5 © 2008-2012, SimplePortal