Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: tirpous on December 03, 2014, 08:33:35 PM
-
I'm doing a retune/overhaul on the bass side of an older Double Ray. On the low bass reeds I could use 'terzetti' leathers which are long enough but just so, or cut down larger and slightly thicker 'bass' leathers. Both would close the slot, but I suspect response may be different, etc... Should one always use the smallest valve that will fit, or is there some kind of guideline to follow ?
-
If you use leather on bass reeds it's essential to also use helper springs. If you don't have them then user the thicker of the valves you have.
-
When replacing either leather or plastic valves you need to make sure you're matching the 'springiness' of the new valve with the one you're replacing. As Theo says with leather valves on larger reeds - the only real way of getting this springiness is to glue a helper spring to the top so that it gives enough resistance. You see this on all factory fitted leather valves. Plastic valves for bass reeds usually have several plastic layers on top which perform the same function.
What you're trying to achieve is the valve opening easily under the lowest pressure you want the reed on the other side to begin sounding. But that has to be balanced with the fact that you also want it to snap shut as quickly as possible after the reed has finished sounding. You need the latter both to give a nice clean finish to the notes - as well as allowing the reed in the opposite bellows direction to start cleanly.
-
Thanks for the replies. I have boosters so all options remain open. I will experiment on a couple of reeds and see how it works.
On this Hohner box, the bass leathers had a mylar booster about 0.12 mm thick, no booster on octave basses. But these leathers are noticeably thicker than my replacements. I guess these thick leather valves are no longer available.
-
Best just to try what you have. There don't seem to be any very precise rules about valving. A bit of trial and error should determine what works.