Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Rog on January 26, 2015, 11:41:45 PM

Title: Hohner Chrome body corners - removal and fitting
Post by: Rog on January 26, 2015, 11:41:45 PM
I have a pre pokerwork Vienna style Hohner, plus a 114 Hohner and I want to replace the chrome corners, but I don't want to wreck the body when removing the old ones. The corners have a little right angle lip that slots into the body. Can someone advise on the method of removing these corners? I've tried gently shifting them with a wedge of hardwood and a light hammer but they refuse to budge. Is it a case of grabbing with pliers and pulling?  Also, what's the best way to fit replacements without destroying/damaging them and the body?
Thanks

OK perhaps should have looked a bit harder... I just found this thread...
http://forum.melodeon.net/index.php/topic,7556.msg93889.html#msg93889

However, if anyone has other tips I'd be grateful. Ta.
Title: Re: Hohner Chrome body corners - removal and fitting
Post by: malcolmbebb on January 27, 2015, 12:58:37 PM
I was just going to look for that thread when I saw your edit!

I was wondering if heating would help, although pondering about how to apply it.
Title: Re: Hohner Chrome body corners - removal and fitting
Post by: Lester on January 27, 2015, 01:24:08 PM
I've done a number of these and do it thusly:

I place the casework so just the chrome bit over hangs the edge of my work bench with the closed end of the chrome bit lowermost. I then take a large flat bladed screwdriver and place it on the open end of the chrome bit and gently tap it off the box. Fitting the new one is done by gently tapping it into place using my little hammer and a block of wood. Both these tasks need doing gently and with plenty of checking that nothing untoward is happening.

ps I once had a box that was so badly corroded that gentle tapping would not budge the chrome bits, in the end I cut them along their length with a Dremel cutting disk and then removed them.
Title: Re: Hohner Chrome body corners - removal and fitting
Post by: Rog on January 27, 2015, 02:37:46 PM
Thank you very much. Using a dremel I 'cleaned up' the terrible corners on my Modell II, leaving a lovely brass look, but though this matches marvellously with the yellow bellows paper, it doesn't look so good against the silver grille and bellows corners.
Title: Re: Hohner Chrome body corners - removal and fitting
Post by: Theo on January 27, 2015, 03:09:47 PM
The brass corners do look nice polished up even when the plating is wearing off.  Steel ones not so good, and you would need to take steps to prevent further rust.  The new ones available now are stainless steel.
Incidentally the plating is not chrome, it is nickel.
Title: Re: Hohner Chrome body corners - removal and fitting
Post by: Rog on January 27, 2015, 03:53:14 PM
Ah thanks. Maybe I'll leave the brass corners as they are then. I was slightly holding back from publishing pictures of my pimped and declubbed Modell II for fear that it might be laughed at. However, it plays extremely well, with a very fast action...
Title: Re: Hohner Chrome body corners - removal and fitting
Post by: Nick Collis Bird on January 27, 2015, 03:58:01 PM
Clacking away one doesn't  hope. >:E
Title: Re: Hohner Chrome body corners - removal and fitting
Post by: Rog on January 27, 2015, 04:03:33 PM
Not really. It's been completely rebuilt/refaced, suited and booted.(:)
SimplePortal 2.3.5 © 2008-2012, SimplePortal