Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: James Tobin on March 18, 2016, 05:02:09 PM
-
Hi, I have a relatively new Scarlatti Nero (12mnths old) and it has a small air leak seems to be coming from around the hand strap on the left side near the air button.Can this just develop through use? Or is it a mechanical fault? I'm a beginner so I've been careful with it and haven't been forcing the bellows. Any advice much appreciated.
-
Hi, I have a relatively new Scarlatti Nero (12mnths old) and it has a small air leak seems to be coming from around the hand strap on the left side near the air button.Can this just develop through use? Or is it a mechanical fault? I'm a beginner so I've been careful with it and haven't been forcing the bellows. Any advice much appreciated.
it is a bit of detective work to find exactly where the air is leaking. the possibilities in no particular order.
the bass pallets not sealing properly,
the air valve not sealing properly,
a hole or crack in the pallet board,
glued seams failing,( unlikely).
to take a closer look you may have to remove the bass board. all common sense really. more qualified members will be along shortly.. brian
-
Great thanks,is this something that could be done by myself? Or does it need to go away to get repaired?
-
Great thanks,is this something that could be done by myself? Or does it need to go away to get repaired?
i think you can investigate this yourself. the bass board is the place where your left hand rests when playing. it is secured with four screws,one in each corner . with the board removed it should be possible to find the source of the air leak.
i am assuming a little DIY skill. only when we know the type of problem,can we suggest a simple fix .or the need for a expert. hope this helps.. brian
-
OK great,I'll take a look
-
Great thanks,is this something that could be done by myself? Or does it need to go away to get repaired?
pic from "project box", shows inside of bass end..
-
Seems to me that the spring holding the flap over thr hole for the air button could do with tightening?
-
Seems to me that the spring holding the flap over thr hole for the air button could do with tightening?
two choices, (1) try and tighten the spring using two pains of pliers to bend the wire: or (2) source a replacement spring and work out how to fit it. you are getting there!! .brian
-
Seems to me that the spring holding the flap over thr hole for the air button could do with tightening?
Now hold it firmly shut with your finger, do whatever you did before to find the leak (assuming that's physically possible) and see if that's cured the leak. Before you start tweaking stuff.
-
With the bass end open clamp the treble end between your knees, open the bellows and then close them and listen for the air leak as you peer in the bass end (this is a faff to do but will work). If you can't locate the air leak by sound, I use either my eyeball up close as this will detect air streams or a small bit of tissue paper which will blow in the wind.
If you think it's a pallet leaking the best thing to do is remove the bass end from the bellows, remove the reed blocks, hold one side up to a bright light source and look on the other side for light bleed.
Don't go bending things until you are sure of the source of the leak.
-
Removing reed blocks etc is a little beyond me I think at this stage of the game..ill 'tweak' gently the spring holding the air button flap..
-
New spring fitted! Many thanks for all the advice.much appreciated :||: