Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: playandteach on April 24, 2016, 09:08:54 PM

Title: Shaving the left hand back edge
Post by: playandteach on April 24, 2016, 09:08:54 PM
Is there any reason why I shouldn't shave the sharp back edge of the left hand side on the Erika I'm fiddling about with? I was thinking of gluing a strip of wood on the inside of the mechanism chamber and shaving a curved edge for comfort (the strip would be to support the newly recessed bottom plate, and allow a deeper chamfer than the thickness of the box would normally allow.
I should add that I am not concerned about originality or resale value. Or even cosmetics. Sorry if that horrifies some folk.
Title: Re: Shaving the left hand back edge
Post by: Lester on April 24, 2016, 09:14:52 PM
I've done this very thing to a number of pokerworks. Just glued a block into the rear of the casework (needs some shaping on the inside so as  not to impede the bass mechanism) then run a router round-over bit to remove the sharp edge on the outside.
Title: Re: Shaving the left hand back edge
Post by: playandteach on April 24, 2016, 09:39:39 PM
Thanks, Lester. No router, so it will be done by hand.
Title: Re: Shaving the left hand back edge
Post by: baz parkes on April 25, 2016, 02:31:38 PM
I :|glug remember sitting next to a maker and fettler of this parish in a session in deepest Wales.  He'd just taken delivery of a box from Louisiana, and found it a tad uncomfortable...answer...Swiss Army knife....
Title: Re: Shaving the left hand back edge
Post by: rees on April 25, 2016, 05:19:05 PM
I :|glug remember sitting next to a maker and fettler of this parish in a session in deepest Wales.  He'd just taken delivery of a box from Louisiana, and found it a tad uncomfortable...answer...Swiss Army knife....

erk!
Title: Re: Shaving the left hand back edge
Post by: Stockaryd on April 26, 2016, 01:06:39 AM
Can we get a photo of such a corner? 
SimplePortal 2.3.5 © 2008-2012, SimplePortal