Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: IanD on June 28, 2009, 12:17:38 PM

Title: Glue for loose bellows corner
Post by: IanD on June 28, 2009, 12:17:38 PM
I'm sure this has been asked before but searching the forums didn't turn up an answer...

What's the best glue for regluing a loose bellows corner? (on a friend's Serenellini)

Ian
Title: Re: Glue for loose bellows corner
Post by: streb on June 28, 2009, 03:38:55 PM
For gluing the cardboard bellows folds to the wooden bellows frame the italian makers recommend a vinyl-based glue. I use "Polyvine" available from Axminster. Apply a generous amount, compress the join and wipe off the excess with a damp cloth. It dries clear in a few hours. I would try to remove as much of the old glue as possible beforehand though. Hope this helps.

Steve
Title: Re: Glue for loose bellows corner
Post by: IanD on June 28, 2009, 04:56:49 PM
For gluing the cardboard bellows folds to the wooden bellows frame the italian makers recommend a vinyl-based glue. I use "Polyvine" available from Axminster. Apply a generous amount, compress the join and wipe off the excess with a damp cloth. It dries clear in a few hours. I would try to remove as much of the old glue as possible beforehand though. Hope this helps.

Steve

Sorry if I wasn't clear -- it's one of the metal bellows corners that's come loose.

Ian
Title: Re: Glue for loose bellows corner
Post by: streb on June 28, 2009, 05:26:31 PM
In that case probably Bostik or UHU.
Title: Re: Glue for loose bellows corner
Post by: Prestidigitator on June 29, 2009, 08:07:46 AM
I'd always thought that they were just crimped on, and not glued.
Title: Re: Glue for loose bellows corner
Post by: Theo on June 29, 2009, 09:30:39 AM
They are when new, but unless you have the crimping machine a replacemet corner needs glue to help keep it in place.
Title: Re: Glue for loose bellows corner
Post by: Prestidigitator on June 29, 2009, 10:07:46 AM
They are when new, but unless you have the crimping machine a replacemet corner needs glue to help keep it in place.

Theo,
I mention it because I had one come off when I was retaping bellows. I opened it out slightly with the flat of a screwdriver and squeezed it back on with a hefty pair of pliers; using a piece of scrap leather over it to avoid marking it.
SimplePortal 2.3.5 © 2008-2012, SimplePortal