Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: LadyEleanore on November 15, 2016, 02:09:03 PM

Title: Bellows leak?
Post by: LadyEleanore on November 15, 2016, 02:09:03 PM
Whilst sitting with the box on my knee and the bellows straps off over the weekend of Witney I noticed that there was a constant pressure against my left hand when holding the bellows closed lightly. Is that normal or does that happen when there is a leak. I can't hear any leakage and I should have asked whilst there but forgot - so much to think about! Usually I'm either practicing or the box has its bellows straps closed and is on its rubber feet so its the first time I've noticed it.
Title: Re: Bellows leak?
Post by: Rob2Hook on November 15, 2016, 02:57:10 PM
Even when brand new all boxes leak just a little.  It's not just the bellows, either.  Air can leak past the pallets or even through less than perfect fittings on the casing.  I believe the most common acceptance test is to hold the treble end up and the bellows should take lionger than 30 seconds to expand fully under the weight of the bass end - though some demand better than that.

I usually fasten the top bellows strap when sitting at a session and not playing for just this reason, then I can take a pull on my beer without the bass end landing on my delicate toes.

Rob.
Title: Re: Bellows leak?
Post by: Garry Probert on November 15, 2016, 04:17:57 PM
Quote
I believe the most common acceptance test is to hold the treble end up and the bellows should take lionger than 30 seconds to expand fully under the weight of the bass end - though some demand better than that.
Many thanks thats a very helpful tip but like the tongue test has caused much mirth in this household ,i had  to explain the principle but now i,m seen as either hanging my melodeons or licking them lol
   
Title: Re: Bellows leak?
Post by: Graham Spencer on November 15, 2016, 04:30:15 PM
Small leaks can be a swine to trace. Some years ago I had an air leak that drove me up the wall. I was conscious of increased air consumption on the push, and when I compressed the bellows with all pallets closed I could hear the very faint sound of escaping air. It took a while, but eventually I found it; a bellows pin that was a slightly less than tight fit in its hole.

Graham
Title: Re: Bellows leak?
Post by: Rog on November 16, 2016, 07:11:23 AM
When refurbing a box...if I have it stripped down the first thing I do is test for leaks, and sometimes use lots of masking tape/paper to block off pallet holes and any other suspect leaking areas, then gradually remove until I find the culprit(s).
Beeswax on bellows pins both stops up leaks but also helps to ease them in/out.
Title: Re: Bellows leak?
Post by: LadyEleanore on November 22, 2016, 09:41:47 PM
I believe the most common acceptance test is to hold the treble end up and the bellows should take lionger than 30 seconds to expand fully under the weight of the bass end - though some demand better than that.

Is that at all likely to damage the valves? I was under the impression that the bellows should never be opened without using the air button. 
Title: Re: Bellows leak?
Post by: Theo on November 22, 2016, 10:00:41 PM

Is that at all likely to damage the valves? I was under the impression that the bellows should never be opened without using the air button.

I think that is a complete myth.  I have seen plenty of bellows damaged by being played hard, but never heard of any damage from pulling or pressing them without pressing any buttons.

I also think that the hanging test is only a very rough guide, for example some leaks can be more problematic when closing the bellows.
Title: Re: Bellows leak?
Post by: triskel on November 22, 2016, 11:47:21 PM
Whilst sitting with the box on my knee and the bellows straps off over the weekend of Witney I noticed that there was a constant pressure against my left hand when holding the bellows closed lightly.

I'd say you were simply experiencing the force of gravity, with the weight of the bass end you'd have to maintain a constant vacuum in the bellows in order to prevent it from happening...

In fact it's WHY you have bellows straps, to prvent them from opening like that.

All perfectly normal!
SimplePortal 2.3.5 © 2008-2012, SimplePortal