Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: boxer on August 11, 2017, 08:48:33 PM

Title: reed mounting etc
Post by: boxer on August 11, 2017, 08:48:33 PM
I've just had a look at the reeds in an old 2-row Hohner of mine and I observe that on each reed block, the two highest pairs of reed plates are in reverse position - that is to say, they are set so that the rivet end of the reed is farthest away from the pallets and soundboard.  I also notice that the bottom (the side opposite the reed plate) of each reed chamber for these reeds is half-filled with wax or something similar, presumably to reduce the volume of the chamber.

Has anyone any idea why this should be so? (the box plays fine)

Title: Re: reed mounting etc
Post by: playandteach on August 11, 2017, 09:25:24 PM
This is also the case on my boxes, and they are also valveless. I had one of my reed blocks tweaked by the maker who had changed the chamber volumes on later models, and the notes are much stronger than before. I imagine the inversion of the plate is to allow the reed to vibrate without fouling the reduced walls.
Title: Re: reed mounting etc
Post by: triskel on August 11, 2017, 10:07:00 PM
The deliberate omission of valves, reversal of the plates, and reduction of chamber depth, are all typical maker's/tuners "tricks" to make the (problematic) highest reeds speak well. Another one you'll sometimes see is a hole, or two, in the wax around the reed frames, to reduce the pressure on the highest reeds, for the same purpose.

Concertina maker's/tuners have some similar techniques as well.
Title: Re: reed mounting etc
Post by: boxer on August 11, 2017, 10:57:08 PM
thanks for those comments. 

The tuner's trick seems to have over-cooked matters a bit, as the (valveless) reeds sound different to the others and are (pressure for pressure) marginally louder than adjacent valved reeds in unmodified chambers.  Although the swing of these reeds is consistent with those around them, they seem a bit quacky (top A) or shrill (top B)(it's a B/C box). 
Title: Re: reed mounting etc
Post by: triskel on August 11, 2017, 11:28:34 PM
... the (valveless) reeds sound different to the others and are (pressure for pressure) marginally louder than adjacent valved reeds in unmodified chambers.  Although the swing of these reeds is consistent with those around them, they seem a bit quacky (top A) or shrill (top B)(it's a B/C box).

They will, but they're probably about as good as they can be, unless somebody's been unkind to them. It was made that way (not modified) and it sounds pretty normal, from what you've said.
Title: Re: reed mounting etc
Post by: gettabettabox on August 11, 2017, 11:52:49 PM
Yep, I guess it's irritating you, but I'd be quite happy with that outcome.  :D
If the swing is consistent with adjacent reeds, I'd leave things be.
Title: Re: reed mounting etc
Post by: boxer on August 12, 2017, 09:33:53 AM
I have another three B/C Hohners of identical or similar type.  They don't seem to have this problem, although I suppose that long-standing familiarity with them may have made me deaf to any similar minor flaws.  I'll have a look at their blocks and listen to their top notes carefully.

Thanks chaps   
SimplePortal 2.3.5 © 2008-2012, SimplePortal