Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Rog on September 08, 2017, 05:55:41 PM

Title: Spring making jig
Post by: Rog on September 08, 2017, 05:55:41 PM
Anyone got some tips on making springs? I normally clamp a rod of suitable size in a vice and wind piano wire using pliers etc. It works as a method, but it isn't very satisfactory. Emmanuel Pariselle has a jig (made of nylon) with various pins that we used to make springs... a clever little gadget. Has anyone got a similar gadget or way of doing it. Previous thread there was a picture of round nosed pliers etc... just wondered if any spring making wizards would care to share their secrets?
Title: Re: Spring making jig
Post by: Pearse Rossa on September 08, 2017, 07:33:36 PM
I have used this method (https://www.youtube.com/watch?v=U4WevVBfalM). It worked for me.
Title: Re: Spring making jig
Post by: Theo on September 08, 2017, 07:44:36 PM
If you use that method and replace the drill
Then you have Emmanuel's spring tool. Set the tube into a conveniently sized small block of wood and turn it by hand. 
Title: Re: Spring making jig
Post by: Rog on September 09, 2017, 07:59:08 AM
Great. Thanks  :||:
Title: Re: Spring making jig
Post by: Psuggmog Volbenz on September 19, 2017, 07:53:27 AM
I usually use parallel, smooth. round jaw  bending pliers to make springs, but have also wound them around a mandrel of desired diameter mounted in a metal turning lathe. I have transfer punches in all the fractional, letter and number drill sizes and have used these as mandrels when inserted in the chuck of a hand cranked antique drill press. I insert one end of the spring wire between the chuck jaws and wind the wire around the mandrel by rotating the drill press quill.
SimplePortal 2.3.5 © 2008-2012, SimplePortal