Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Henry Piper on September 20, 2017, 07:32:09 PM

Title: Wire Pallet arms.
Post by: Henry Piper on September 20, 2017, 07:32:09 PM
Simple question I hope !!  whats the best Wire to fashion pallet arms from?.
Title: Re: Wire Pallet arms.
Post by: rees on September 20, 2017, 08:21:09 PM
Fancy Italian boxes use galvanised fencing wire. I use steel welding rods - posh, me!
Title: Re: Wire Pallet arms.
Post by: malcolmbebb on September 20, 2017, 09:35:40 PM
Fancy Italian boxes use galvanised fencing wire. I use steel welding rods - posh, me!
Takes him bloody ages to scrape the flux off though.
Title: Re: Wire Pallet arms.
Post by: rees on September 21, 2017, 02:00:14 AM
Fancy Italian boxes use galvanised fencing wire. I use steel welding rods - posh, me!
Takes him bloody ages to scrape the flux off though.

Flux off!
Title: Re: Wire Pallet arms.
Post by: melodeon on September 21, 2017, 11:41:04 PM
Galvanizing

"It was named in English via French from the name of Italian scientist Luigi Galvani. "

FYI   : )
Title: Re: Wire Pallet arms.
Post by: boxcall on September 22, 2017, 03:34:46 AM
My beltuna looks like the galv. Stuff about 3/32" in diameter. No fancy bends either.
What size / diameter do you use Rees?  If you can share.
I imagine the galvanized must be easier to bend into shape and out of shape.
I'm wondering what method is used to hold the wire in place where it goes though the wooden lever?
I think Blafleur does some kind of flat spot after he pushes it though the hole then taps it back in.
Maybe that's the norm.

Edited to fix mistake.
Title: Re: Wire Pallet arms.
Post by: malcolmbebb on September 22, 2017, 08:40:27 AM
Hohner Student PAs use steel wire, looks like galv, I make it 2.1mm dia.  Seen similar on a couple of cheap old PAs. I suspect it's glued into the levers but not sure.
Title: Re: Wire Pallet arms.
Post by: rees on September 22, 2017, 09:28:38 AM
I use 2.4mm welding rod. Push it through the wooden lever, hammer the end flat, apply a smear of Araldite and tap it back in.
It's best if the flat aligns with the grain of the wood to prevent splitting.
Title: Re: Wire Pallet arms.
Post by: Tone Dumb Greg on September 22, 2017, 10:08:03 AM
Galvanizing

"It was named in English via French from the name of Italian scientist Luigi Galvani. "

FYI   : )


Better known for inventing a device to make the legs of dead frogs twitch.
Title: Re: Wire Pallet arms.
Post by: boxcall on September 22, 2017, 10:17:33 AM
I use 2.4mm welding rod. Push it through the wooden lever, hammer the end flat, apply a smear of Araldite and tap it back in.
It's best if the flat aligns with the grain of the wood to prevent splitting.
Thanks Rees and that made me look again at my beltuna diameter which I got wrong it's 3/32 or 2.4mm, that's what happens when posting past my bed time.

I'll edit my post :-[
SimplePortal 2.3.5 © 2008-2012, SimplePortal