Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: David P on May 03, 2018, 05:25:30 PM

Title: Valve length
Post by: David P on May 03, 2018, 05:25:30 PM
My wife's concertina started to produce a single "ghost" note when various keys were depressed on one side, with the bellows on the pull.

On opening it up, I found that a valve had buckled slightly and the tip was getting caught in the end of the reed box chamber.  The valve had been trimmed very short and at a slight angle and was not completely overlapping the end of the reed box chamber and was therefore catching inside the chamber and the reed was sounding from time to time.

I replaced the valve with a slightly longer version and the "ghost" note is no more.

On checking the rest I found that several valves had been cut so that they were only just resting on the end of their reed chambers, and several appear to have been deliberately trimmed at an angle so that they have left a minute triangle of the reed chamber not covered.  There are no other "ghost" notes.

The question is:  (and also thinking about my own melodeons)

Should the valve overlap the reed chamber by say, two to four mm all round to effectively seal the chamber, or is the above as described normal practice ?
Title: Re: Valve length
Post by: Steve_freereeder on May 03, 2018, 06:43:27 PM
I can't quite visualise your description - or decide whether you are writing about valves for 'real' concertina reeds or accordion-type concertina reeds.
Nevertheless, I think the advice should always be that valves (a) should completely overlap the sides and end of the slot in the reed plate or frame with no gap, and (b) should not catch on any internal part of the reed chamber side or end.

This applies for both concertina and melodeon/accordion instruments.
Title: Re: Valve length
Post by: tirpous on May 04, 2018, 03:59:15 PM
Not sure for concertinas, but on melodeons, the valve is usually cut just long enough to cover the reed slot, i.e. end overlap of about 1 mm (4mm is too much).   
Title: Re: Valve length
Post by: Theo on May 04, 2018, 04:02:06 PM
On some concertinas the valves on the one or two highest notes are sometimes fitted with w gap at the end where the windway is not completely covered. 
SimplePortal 2.3.5 © 2008-2012, SimplePortal