Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Stockaryd on September 22, 2018, 07:02:58 PM
-
I just want to know. (:)
To lower the tone of a reed you can put a heavy blobb on the tongue
Does anyone really do that?
1 How did it work out?
2 What was the weight? Tin? Brass? Other?
3 How was the weight attached? Glue? Soldering? Rivet? Other?
-
This is where being ignorant and fearless comes in handy!
I tuned a set of old reeds (from a scrap PA) to fit into a melodeon as a D/G, using solder here and there, but I didn't like it. So I then lowered most of half of them by an octave to change it into bandonion tuning. On the bigger reeds, I stole some of the brass weights from some other old bass reeds and cut them up to glue on to the ones I was using. On the others I dropped a blob of solder onto the tip and filed them up to more or less where I wanted them to be. Worked a treat.
But then again, who am I to tell if they actually do work a treat?
-
Sounds fun.
An old PA is exactly what I have. And is fearless in some! area.
Glue . . superglue? Other?
Thinking of PlasticPadding, which attaches to metal.
vague plans to modify a toy melodeon. Just for fun.
-
It has to be superglue for me, £1 for 10 small tubes at the local cheap shop. I know that it's frowned upon in certain circles, but you have to "cut your suit according to your cloth".
"Lower the tone"? I think I already did that!
-
gorilla superglue with both brush and nozzle is very useful particularly when using the brush to put very small amounts precisely. It also keeps for ages without going off.
george
-
vague plans to modify a toy melodeon. Just for fun.
Toy melodeon reeds are not responsive at the best of times. Weighting the ends is likely to make them worse!
-
Re the toy melodeon - I have fitted three of them with single row / voice of steel reeds.One has Hohner reeds in key of G, second button start fits almost perfectly - just the biggest reed chamber needed a bit of cutting to enlarge it.
The others have Cagnoni reeds in D (also 2nd button start)and I had to make the reed block from scratch. Single voice again so it was quite easy. Single voice means the ineffecient bellows work ok, especially the shrill G one.
I took out the chords and replaced them with accidentals.
Everyone who has heard them seems to like them.
The original brass reeds are rubbish in my opinion. I tuned them dry and they sounded loveley for a few hours only, as the tuning drifted.
Off topic now- Apologies.
-
A blob of solder on the end of the reed tongue is common practice amongst us fettlers.
It works a treat on low reeds but I don't use it on the high notes.
-
I've seen a Pokerwork tuned dry by tbe addition of Tippex to the tips of the M+ reeds. Apparently it had been on there for 10 years with no problem....wouldn't recommend it myself though.
Martyn
-
I've seen a Pokerwork tuned dry by tbe addition of Tippex to the tips of the M+ reeds. Apparently it had been on there for 10 years with no problem....wouldn't recommend it myself though.
Martyn
Aye, nail varnish too ......... and paint ..... and one time only, wax! - that one was fun!
-
I suppose if the tuning is wrong a bit of correction fluid is just the job :||: fetches coat