Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Rog on December 12, 2018, 10:59:50 AM
-
What’s the best substance to dissolve new/sticky Reed wax (in the UK)? I normally get by with alcohol / ultrasound and scraping, but I’ve got a set of reeds coated all over with new sticky wax (where someone tried to do the waxing themselves and messed it up). It’s in all sorts of places where you don’t want it so I really need to effectively dissolve it.
-
I use pure alcohol on a cotton bud to clean small local areas, don't know how it would cope with larger bits.
SJ
-
Hi Roger, you mentioned you have an ultrasound. Part fill this with water, find a glass or ceramic pot just large enough for your reed place in ultrasound and fill this with WD40. Run ultrasound, wax should desolve in WD40, renew as required. This way you do not contaminate the ultrasound and most (not all) the ultrasound energy is transmitted to the object to be cleaned, do not use plastic or anything soft as the ultrasound will be absorbed and dampened.
-
Sorry Roger should also have mentioned placing reeds in the deep freeze for an hour or two, should harden the wax and enable your normal scraping to remove.
-
To me, Grumpy's suggestion certainly sounds the easiest. Although, I've had a certain level of success just using lighter fluid to melt (dissolve) the wax and wiping off with a cotton bud. (But don't smoke while you're on with it!)
-
I've been known to pop reedplates into a petrol bath (in the open air, in a safe container and in a safe place!) which works fine on old wax; I should think it would work with fresh stuff too.
Graham
-
What’s the best substance to dissolve new/sticky Reed wax (in the UK)? I normally get by with alcohol / ultrasound and scraping, but I’ve got a set of reeds coated all over with new sticky wax (where someone tried to do the waxing themselves and messed it up). It’s in all sorts of places where you don’t want it so I really need to effectively dissolve it.
I use industrial standard (99% purity) acetone which is readily and cheaply availble from on-line sources (try Amazon). It dissolves wax very effectively, while also being of low toxicity. I use a shallow non-plastic dish or tray to hold the reed plates and pour in just enough acetone to cover them. Leave for a couple of minutes and agitate gently. Most of the wax dissolves and any residue can be easily wiped off with a cotton rag or cotton bud moistened with fresh acetone or methylated spirit. Needless to say, do this in a well-ventilated place and away from any sources of flame.
Spent acetone/wax solution can be stored in a glass container and can be used to start garden bonfires. Don't pour it down the sink or into drains.
-
That seems a bit expensive for us cheapskates, Steve. Also, lighter fuel/petrol would evaporate. or the little that's used could just be burned off outside, anyway.
-
Acetone evaporators even faster than lighter fuel. For a cheap supply of acetone try nail varnish remover.
-
That’s handy. I have a bottle of acetone. So does this work better than, say, meths, or is it just another solvent that'll do the job? Maybe I should experiment.
-
That seems a bit expensive for us cheapskates, Steve. Also, lighter fuel/petrol would evaporate. or the little that's used could just be burned off outside, anyway.
At £9.99 per litre here (https://www.amazon.co.uk/LITRE-ACETONE-99-5-POLISH-REMOVER/dp/B00GJK3SLI/ref=sr_1_11?ie=UTF8&qid=1544626456&sr=8-11&keywords=acetone+solvent), that's cheap enough even for cheapskates. You could probably find it even more cheaply with some google searching around.
Acetone evaporates pretty quickly too, but not before it's done its job.
That’s handy. I have a bottle of acetone. So does this work better than, say, meths, or is it just another solvent that'll do the job? Maybe I should experiment.
It works much better than meths. Less toxic too.
Acetone evaporators even faster than lighter fuel. For a cheap supply of acetone try nail varnish remover.
Nail polish remover (NPR) works out more expensive per unit volume than industrial acetone. With NPR you pay for the packaging and cosmetic marketing mark-up. Also, be aware that some NPR is acetone free so may not do the de-waxing as thoroughly. Also some acetone-based NPR contains lanolin and other oily moisturisers, which may not be desirable when it comes to gluing valves on to reed plates after de-waxing.
-
But nail polish remover is easily available and in small quantities
This one is described as pure acetone. (https://www.amazon.co.uk/Acetone-Superior-Quality-Polish-Remover/dp/B0182QCU7E/ref=lp_118484031_1_1_sspa?s=beauty&ie=UTF8&qid=1544627758&sr=1-1-spons&psc=1).
-
Steve, you and I must move in very different "cheapskate" circles! (I'm still looking for premium petrol at 5/- a gallon!!!)
But I have to agree with you about the nail varnish swag, my Number One Daughter knows all about that sort of stuff with her "Beauty" shop.
-
Steve, you and I must move in very different "cheapskate" circles! (I'm still looking for premium petrol at 5/- a gallon!!!)
But I have to agree with you about the nail varnish swag, my Number One Daughter knows all about that sort of stuff with her "Beauty" shop.
I have to agree with you, WS, but then I don't live in the UK any more! Here in Cyprus a litre of acetone (or indeed a litre of alcohol - both available off any supermarket shelf) sets me back about 2 or at most 2.50 euros. OK, it might not be industrial quality, but it works and it's cheap. I've tried both on reed wax and other stubborn box-related cleaning jobs, and though they both work I find petrol quicker and more thorough on old dried-out wax. No idea what petrol costs in UK these days - here it averages out around 1.33 euros (about £1.20) a litre, so it's actually cheaper than some other cleaning agents.
Graham
-
A shallow tray of 100% acetone has done the trick. I’ve just washed the reeds and they are clean, all the sticky wax has come off. The blue gloves I was wearing were ok, but I thought one had a hole so I switched to some white plastic gloves..and the acetone instantly melted the finger tips... :o
I’ve got the acetone at the moment in a lidded plastic takeaway food tray, sitting in a metal tray. It doesn’t seem to have melted the tray and it came out of a plastic bottle...but the metal tray is there for safety. Now I have to find out how to dispose of this stuff. Maybe just store and reuse it.
-
A shallow tray of 100% acetone has done the trick. I’ve just washed the reeds and they are clean, all the sticky wax has come off. The blue gloves I was wearing were ok, but I thought one had a hole so I switched to some white plastic gloves..and the acetone instantly melted the finger tips... :o
I’ve got the acetone at the moment in a lidded plastic takeaway food tray, sitting in a metal tray. It doesn’t seem to have melted the tray and it came out of a plastic bottle...but the metal tray is there for safety. Now I have to find out how to dispose of this stuff. Maybe just store and reuse it.
I have found that you can reuse the acetone once or perhaps twice, but eventually it has too much wax dissolved in it, and starts to leave a milky, waxy film on the reed plates. After that, the acetone/wax mixture is not worth reusing. Store in a glass jar or bottle, or use it on screwed-up newspaper as firelighters.
You can easily remove any milky film on the reed plates with fresh acetone or a cotton bud moistened with meths.
-
At a guess, the blue gloves are probably nitrile or, just possibly, polythene. The white gloves are probably latex. Butyle would be a better choice than any of those.