Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Rog on March 27, 2019, 05:06:53 PM

Title: Straightening a bent brass axle
Post by: Rog on March 27, 2019, 05:06:53 PM
I used a variation on the method shown in this video to straighten a bent 2.5mm brass axle. In fact I used a pillar drill, and because the axle is 350mm long I ended up with two bits of wood with 4mm holes (just off cuts, but at least 400mm long). The axle does whip around unless you keep a hold of it with the drilled wood until it has stopped rotating, so I used one piece of wood to hold the free end and the other to straighten kinks further up the axle. Kinks near the free end can be straightened with just one bit if wood. The timber I used was quite soft...probably get better result with a harder wood.  I have no idea if this works with a steel axle, but it worked pretty well with brass. I’ve got a friend who repairs brass instruments and he alerted me to this idea.
https://youtu.be/RvPTAIAF5EQ
Title: Re: Straightening a bent brass axle
Post by: John MacKenzie (Cugiok) on March 27, 2019, 05:51:54 PM
Well who'd have known that that would work. Thanks a lot, very useful.

SJ
Title: Re: Straightening a bent brass axle
Post by: Steve_freereeder on March 27, 2019, 06:04:32 PM
I have no idea if this works with a steel axle ...
The video shows the method used to straighten a saxophone axle rod. These rods are made of steel, so it should work for a steel melodeon axle rod.
Title: Re: Straightening a bent brass axle
Post by: george garside on March 27, 2019, 08:05:06 PM
brass and steel rod is readily available from model shops and ? on t'internet in metre lengths and various diameters

george
Title: Re: Straightening a bent brass axle
Post by: Theo on March 27, 2019, 08:16:54 PM
Thanks for that Roger.  Looks like a pretty quick process, I’ll remember this n dg time I have a bent axle rod to repair.
Title: Re: Straightening a bent brass axle
Post by: Squeaky Pete on March 27, 2019, 08:17:50 PM
It's how I straighten out long drills for bagpipe making. 3mm dia and 250mm long is always a bit vulnerable.
Title: Re: Straightening a bent brass axle
Post by: Man1nvan on March 27, 2019, 11:11:49 PM
Genius!
Title: Re: Straightening a bent brass axle
Post by: Kimric Smythe on March 30, 2019, 06:47:59 AM
I was unaware of this particular fetish. I am always up for some tool porn.
SimplePortal 2.3.5 © 2008-2012, SimplePortal