Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Squeaky Pete on May 29, 2019, 10:17:57 AM

Title: Slow honking Hohner club basses
Post by: Squeaky Pete on May 29, 2019, 10:17:57 AM
On a few basses the really low reed is a bit slow to respond and then produces its wonderful deep honking bass. More than once I've thought I could hear someone walking upstairs when it's just the valve opening and closing.
Is this just a result of the inertia and mass of the weight soldered on, or can I improve the response?
Title: Re: Slow honking Hohner club basses
Post by: Rog on May 29, 2019, 12:55:25 PM
You can check the response on a tuning table, if you have one, by removing the reed block and testing, experimenting with different rates of airflow. Big bass reeds sometimes need a surpringly big gap between the tip and the slot to work optimally. Also, if your valves are old and a bit stiff they might take longer to close which would also slow down reed response.
Title: Re: Slow honking Hohner club basses
Post by: Squeaky Pete on May 29, 2019, 04:10:34 PM
Yes I pulled the gap open a bit more and everything sounded better. I'm going to have to replace a couple of valves too. They certainly speak faster with the valves held shut.
Title: Re: Slow honking Hohner club basses
Post by: Squeaky Pete on June 01, 2019, 04:07:03 PM
As a final check when I had the bottom end open I pulled off the curled valves and turned them over.
I realise this is an illegal move and only affects the push reeds but the difference between push and pull, especially on Bb, was remarkable.
New valves will arrive next week and I'll do it properly.
SimplePortal 2.3.5 © 2008-2012, SimplePortal