Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Peadar on June 18, 2019, 10:26:32 PM

Title: Tuning Table-Sensible size
Post by: Peadar on June 18, 2019, 10:26:32 PM
Any suggestions as to a sensible size for the working surface of a tuning table?  Intending to use Lester's approach of using a spare reed block as "carrier" for individual reeds. Also intend using it to tune long plate reeds.

Title: Re: Tuning Table-Sensible size
Post by: Rog on June 19, 2019, 08:49:34 AM
If you plan to tune PA reed blocks, the big ones - sometimes 22 plates long - consider how far each side of the central table  holes it is going to protrude, when you are tuning an end reed.  If you have seen Lester's tuning rig I think it might be a bit narrow for PA blocks. But Lester might disagree...
Title: Re: Tuning Table-Sensible size
Post by: Winston Smith on June 19, 2019, 12:32:13 PM
My suggestion for size (in the example which RogerT gives) would be to have the surface of your table long enough so that when the end reed is over the blow hole, you can let go of the block without it falling off! This could mean (depending what actual space you have) that your blow hole has to be off-centre.
Title: Re: Tuning Table-Sensible size
Post by: Lester on June 19, 2019, 12:37:07 PM
Mine is 330mm wide, this was driven by the bellows I had. The hole is in the middle so full support 160mm either side. A pokerwork reed block is 230mm so it overlaps the edge when tuning and a piano accordion block would overlap more but this has never ever caused a problem.
Title: Re: Tuning Table-Sensible size
Post by: Peadar on June 19, 2019, 06:16:52 PM
Thanks Guys - I think that's enough information to let me make something functional. Photos to follow - that's a challenge to myself to actually make it!
Title: Re: Tuning Table-Sensible size
Post by: Peadar on June 30, 2019, 12:37:13 AM
Sometime later.....

Box is 50mm deep, 350 mm front to back and 400mm wide.

P.
Title: Re: Tuning Table-Sensible size
Post by: Winston Smith on June 30, 2019, 06:46:07 AM
Very nice, but I could imagine it becoming quite wearing on the arm and shoulder with constantly lifting the bellows against the restriction of dragging air through the small blow-hole. Time will tell.
Title: Re: Tuning Table-Sensible size
Post by: malcolmbebb on June 30, 2019, 07:50:00 AM
Lester has an air button to allow faster refill. I’m sure he will enlighten you.
SimplePortal 2.3.5 © 2008-2012, SimplePortal