Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: komat on July 24, 2019, 03:25:25 PM

Title: Dull reed sound
Post by: komat on July 24, 2019, 03:25:25 PM
Hi all,

I’ve been doing some minor tuning work on one of my 2 voice boxes. One particular set of reeds (same button, 2 voices on the push) sounds considerably duller than the rest of the notes in the same row, and even the same note found on the inside row on the push as well. Both sets of reeds (outside and inside row twin notes) are tuned the same, with new wax good valves. Any idea of what’s going on?
Title: Re: Dull reed sound
Post by: Theo on July 24, 2019, 03:34:07 PM
That's hard to diagnose remotely!   A bit like phoning the mechanic when your car is loosing power and asking what's wrong!

The most common cause of this in my experience is the valve hanging up against the side of the reed chamber.  With the block out look into the vent while depressing the reed tongue from outside so that it pushes the inside valve open.   The valve should move freely, and close completely without touching the wall of the reed chamber or wood fibres sticking out from the wood.  Bits of wax can sometimes get in the way too.

Less likely: traces of wax on the edge of reed tongue; glue spread from the valve to the edge of the reed tongue; reed tongue off centre; reed set too low. 
SimplePortal 2.3.5 © 2008-2012, SimplePortal