Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Johnny S on August 27, 2020, 06:58:57 PM

Title: Crack/gap between reed plate and wax
Post by: Johnny S on August 27, 2020, 06:58:57 PM
If there is a slight gap between the reed plate and the securing wax, but the plate feels secure and the reed sounds well, would you leave well alone or try and reset the wax along that plate edge?
Title: Re: Crack/gap between reed plate and wax
Post by: Tiposx on August 27, 2020, 07:34:56 PM
If the wax looked good (not dry or dark) I would run my soldering iron-based waxing tool along it lightly. If that didn’t work then I would  re-wax whilst being ready for the whole lot needing a re-wax.
Title: Re: Crack/gap between reed plate and wax
Post by: Rob2Hook on August 27, 2020, 09:18:49 PM
Exactly that, do a repair o stop the leak from getting worse.  No box is truly airtight but few have any major problems, just an accumulation of minor ones.  Be aware though that the problem may flare up as the  wax ages further, so keep an eye out for any breathiness or noticeable loss of air.   Actually if you're methodical re-waxing isn't too big a deal. - it's when you decide to re-valve, reset and retune as well it gets complicated.

Rob.
Title: Re: Crack/gap between reed plate and wax
Post by: Theo on August 27, 2020, 09:30:14 PM
On the other hand when you get to the point of needing a full re-wax it’s false economy to not replace all the valves while you have the opportunity. In the past I’ve  done a small number of re-waxing jobs without replacing valves, and I’ve always regretted it later.
SimplePortal 2.3.5 © 2008-2012, SimplePortal