Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: mselic on September 17, 2020, 01:49:16 PM
-
I’m wondering if folks who use the traditional spoon method for waxing reeds can let know how they keep wax from building up (quickly) on the spoon. I found in the past that the wax cools down rather quickly on such a large surface area and then solidifies, making it difficult to use the spoon effectively.
-
Make sure your wax has reached a sufficiently high (but not too high!) temperature. It must flow almost like water. And of course you should work with a certain speed. I usually use one half-filled spoon of wax for three to four spaces between reeds, one (well filled) for the front and another one for the back. I should add that I use the German type, not the Italian spatula.
-
Yes I struggle with the Italian type spoon, and find this style easier for me.
https://www.akkordeonshop24.de/en/wax-spoon.html
SJ
-
I make little “worms†of wax, lay them in place and tickle with a “not too hot†soldering iron 😔
On one field repair I had to use a warmed up tent peg! 😉
-
I kept things warm with a hair dryer Until I was sure everything was sorted.
-
I use the half-circle tool. I call that a spoon, but that term also gets used for the small trough-like tools. I'm guessing this is the same type of tool you are using, mselic? I was going to say the same thing Pearse said: keep it immersed. I get a rhythm going where I immerse the spoon for a couple of beats to heat it up, turn it sideways, drag it against the bar to clean the wax from one side, hold it horizontal to keep the wax from dripping, and bring it to the spot to be waxed. It helps to be holding the reedblock in my non-dominant hand, rather close to the wax pot, so there isn't much travel happening. I would say the final moment of approach between block and spoon is actually my block hand moving, so the spoon doesn't drip.
-
I use an Italian style flat spoon with a Carini supplied heater. The flow of wax is controlled by tilting the spoon. I made a video (on YT) showing this technique. However, if you buy some of Charlie Marshall's wax sticks and use a soldering iron, then that works very well, if there is a gap between your reed plates.
-
Since I started using the flat spoon spatula thingy I’ve cut my waxing time in half, my old method was to pour hot wax between the Reed plates angling the reed block to manipulate the wax with mixed results, plus spend time to neaten the job up , the flat spoon works a treat for me .