Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: baz parkes on May 08, 2021, 06:09:21 PM
-
The squeak level on my C/F Pressedwood has gone from "Aren't old Hohners Endearing" through "That's a bit annoying" to "Please make it stop, I can't play..." (though some might say that's a blessing...). I have spent the princely sum of £4.75 0n some powdered graphite. What is the best way to apply it please....
-
As Steve Dumpleton would have said, nd because I've tried his suggestion and it works, mix some with some meths and apply it, the meths will evaporate leaving the graphite where you want it.
-
But first do some detective work and pin down the source of the squeak so you can put the smallest amount of graphite in the correct place.
-
Thanks both... :|glug
-
As you'll not notice any missing from the pack when you're done - graphite is also commonly used mixed to a thick paste with Vaseline as a nut sauce on guitars, etc.
Rob
-
I would check the springs to see if they are all sitting in the middle of the slots first (:) if too close or touching the arms they do squeak..just push them in the middle if they are touching.springs should sit in the middle with enough gap on both side of the slot..I'd also check non of the buttons hitting the key board when pressed down.
-
Thanks both... :|glug
Drink to me only wi'thy advice
And I'll not ask for meths?