Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Peadar on May 26, 2021, 10:51:40 PM

Title: International -Vienna Type - 6Bass Broken Spring in bass machine...
Post by: Peadar on May 26, 2021, 10:51:40 PM
One of the buttons went down and didn't come back up.....looks like a broken spring. Photo will have to wait till I work out how to get photos off the new phone.

This is an old (catalogue evidence from 1903) model though may have stayed in production till the demise of Dienst in 1935.

Wooden  block slotted for wooden action levers is glued in . there appear to be trigger springs under the action levers...and the arm of one of these has broken off.

This looks like it's going to be a slow and high risk job.

Title: Re: International -Vienna Type - 6Bass Broken Spring in bass machine...
Post by: Peadar on May 28, 2021, 12:42:29 AM
Now I see that the springsare inserted between the cheeks of the lever slots.... It turns out that neither of the A springs are original.
A substitute appears to have been wound from hard brass wire- this isn't the first time I have seen brass wire used in replacement springs though they invariably feel stiffer and soggier than the steel originals.
Got the remains out. extracted a sustitute from a PA keyboard,,,,and pushed it too far in. Aaaagh!!! Now how do I get  that spring back out....
Title: Re: International -Vienna Type - 6Bass Broken Spring in bass machine...
Post by: Winston Smith on May 28, 2021, 07:12:36 AM
Hopefully, you've got a slight curve on one leg of the spring. You could then make a hook to go past the end of the other leg and carefully pull it outwards until you can get something in between the sharp spring end and the slot, to stop that leg digging in to the wood as you extract the whole spring.
Best of luck!
Title: Re: International -Vienna Type - 6Bass Broken Spring in bass machine...
Post by: Peadar on May 28, 2021, 02:41:50 PM
Hopefully, you've got a slight curve on one leg of the spring. You could then make a hook to go past the end of the other leg and carefully pull it outwards until you can get something in between the sharp spring end and the slot, to stop that leg digging in to the wood as you extract the whole spring.
Best of luck!

Aye. I have a curve on the spring alright....the wrong sort of curve. When I knock off for the day I'll have another attempt.
Title: Re: International -Vienna Type - 6Bass Broken Spring in bass machine...
Post by: Peadar on May 28, 2021, 10:52:18 PM
Success! - and relief

The tool that finally got it out was a pair of old "BB" horologists' tweezers (blunter and heavier than the NN tweezers used for watch work).

The second time round the replacement spring came from the bass machine of one of those despised Alvari PA's .... which when I looked at it was  identical in construction to the International bass machine.

Inserted the spring manipulating it with the BB tweezers and a flat blade precision screwdriver. ( & Thanks for all the advice) (:)
Title: Re: International -Vienna Type - 6Bass Broken Spring in bass machine...
Post by: Theo on May 28, 2021, 11:13:22 PM
A very useful tool for manipulating springs is an artery clamp.    It works like heavy tweezers with a locking mechanism.
SimplePortal 2.3.5 © 2008-2012, SimplePortal