Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: dino.pafftti on November 11, 2021, 01:35:09 PM
-
Hi...
Maybe I should change the bellow tape, But how do I get them removed ? I'm afraid the bellows paper will come off ,, :Ph
The tape has a good glue ..
-
bellow nauha = bellow tape ;D
-
Maybe I can do this ?? ::) What do you think ?
-
Hello Uncle Risto, of course you can do it!
Lester Bailey has a "How to" video on YouTube:
https://www.youtube.com/watch?v=UhdyuQ9AMsg&ab_channel=LesterBailey (https://www.youtube.com/watch?v=UhdyuQ9AMsg&ab_channel=LesterBailey)
I hope you are well?
-
On an older bellows like this the glue is likely to be something that can be softened or released with water. If the old edging does not come off easily then apply warm water with a brush or spray, then leave for 20 minutes inside a plastic bag to allow the water to penetrate. A small amount of detergent in the water may help, and if the surface is shiny then a light rubbing with abrasive paper will cut through the surface and allow water to be absorbed more quickly.
-
Hello Uncle Risto, of course you can do it!
Lester Bailey has a "How to" video on YouTube:
https://www.youtube.com/watch?v=UhdyuQ9AMsg&ab_channel=LesterBailey (https://www.youtube.com/watch?v=UhdyuQ9AMsg&ab_channel=LesterBailey)
I hope you are well?
Thanks
Lester Bailey in the video is a bellow tape, paper type ,, I think it's easier to remove ,, My bellows tape, something "faux leather"
Very strong glue ,,
I'm fine, Christmas is expected (:)
-
On an older bellows like this the glue is likely to be something that can be softened or released with water. If the old edging does not come off easily then apply warm water with a brush or spray, then leave for 20 minutes inside a plastic bag to allow the water to penetrate. A small amount of detergent in the water may help, and if the surface is shiny then a light rubbing with abrasive paper will cut through the surface and allow water to be absorbed more quickly.
Thanks Theo.. (:) That's a good guide, I'll give it a try .. The paper under the tape, I'm afraid it will come off / tear
-
If you work slowly and carefully the paper underneath should be ok.
-
Ok .I trying .. I'm always too busy Haha ..
-
I often add about 15% alcohol to help break the surface tension of the water and help it penetrate.