Melodeon.net Forums

Discussions => Recordings and Videos => Topic started by: Rog on March 03, 2022, 06:50:07 PM

Title: Colombian accordion tuner at work
Post by: Rog on March 03, 2022, 06:50:07 PM
https://youtu.be/lHi9W0YxFTI

Cue: outraged forum members at his use of a rotary tool…
 (:)
Title: Re: Colombian accordion tuner at work
Post by: mselic on March 03, 2022, 07:38:02 PM
I have to admit the sparks flying off the reeds makes me cringe… ;D
Title: Re: Colombian accordion tuner at work
Post by: Theo on March 03, 2022, 07:49:09 PM
Without understanding his words it’s hard to tell exactly what he is trying to demonstrate.  It all looks a bit haphazard though.  Should get all the valves right first, then pre-tune if necessary,  then tune with the blocks inside the instrument.  And the grinder -  it’s so slow the way he does it.  Ok for a few reeds but adds a lot of time in a full retune.
Title: Re: Colombian accordion tuner at work
Post by: Winston Smith on March 03, 2022, 08:03:22 PM
If you could file fast enough, you could possibly get some sparks going!

When I was building my bass instrument, I needed some reeds (on more or less normal sized plates) to go pretty low. I used some PA bass reeds, and after looking at some others, it was plainly obvious that they had been ground down using a rotary stone of some description.
In for a penny and in for a pound! I took a few down a long way, without having to overload them with solder, by carefully and neatly grinding away the lower portion of the reed tongue to about half it's thickness for about a third of its length. I had noticed a good number of original reeds which were done that way.

I've also seen a great number of original treble end reeds with rotary stone markings on them, when I've been using a file or a scratcher.
Title: Re: Colombian accordion tuner at work
Post by: Theo on March 03, 2022, 08:51:55 PM
Hohner reeds are tuned at the factory using a grinder.  Italian reeds not.

Why do you want to avoid loading reed tips with solder?  You can often get a better performing reed that way.  Thinning too much can exacerbate the tendency for the pitch to flatten when played hard.
Title: Re: Colombian accordion tuner at work
Post by: Winston Smith on March 03, 2022, 09:13:05 PM
Even older Italian reeds? I'm sure that some of the ones I'm talking about were out of old Italian PA's.

I didn't want to avoid using solder, it's just that they will only take a certain  amount before it all starts to fall off!
Title: Re: Colombian accordion tuner at work
Post by: Rog on March 03, 2022, 10:35:17 PM
Well it looks like a thriving business in Medellin (lots of Hohner three rows), so I guess however he does it, it works ok.
Title: Re: Colombian accordion tuner at work
Post by: komat on April 08, 2022, 03:31:57 PM
The sparks!  :o
SimplePortal 2.3.5 © 2008-2012, SimplePortal