Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Ross Dubois on March 12, 2022, 04:44:01 PM
-
The title says it all; are these keyboards interchangeable or are they specific in their mounting profile? I am curious about cross compatibility here. The question may have already been asked but I couldnt find the answer.
Thanks!
-
Mostly yes. The pearloid Double Ray that is the same shape as the Erica have interchangeable keyboards. The pokerwork and early Double Ray that are the same square shape also have interchangeable keyboards.
-
Hey Theo, thanks for the reply!
Ah I see, so would you say that the pokerwork keyboard is not interchangeable with the not-blocky, 'curvy' erica/double ray? Thats what Im mostly curious about. Ive got a wooden keyboard off a pokerwork body that was beyond saving (so Ive been told) and have been pondering the possibility of swapping out my plastic Double Ray keyboard. If they arent cross compatible, knowing this would save me a lot of time, haha.
-
The answer to your question is yes...and no.....
The back edges of the keyboard of Erica-shaped instrument have a little cutaway at each end, approximately 10 x 2 mm, whereas the pokerwork has a dead straight edge, so those cutaways will need to be replicated to ensure a snug fit. Reuse the woodscrews to fit, perhaps with a leather washer to maintain airtightness.
I would not recommend trying to fit the plastic keyboard to the pokerwork; a much more tricky task to fill in the cutaways; but as it seems that you are likely to be scrapping the pokerwork, I won't comment further.
One other problem you may need to overcome is that you might find the buttons (and the button holes) are of slightly different sizes depending on the age of the instruments. Just might be an issue....
Good luck.
-
Thanks for the help Malcom!
Armed with your information, I took the keyboard off the pokerwork and indeed, totally flat on the bottom, whereas the double ray has the cutaways you mentioned. Now I need to ponder a way to route those sections out of the wooden pokerwork keyboard to make this... work.
I could probably use a router, but very careful sanding would probably do the job as well. I have a small banded belt sander that has variable speed, but by hand, while tedious, might be safer.
Ultimately I plan on refinishing the keyboard and case of the doubleray as well as replace the buttons with modern replacements (12.5mm buttons seems to fit the pokerworks keyboard nicely) so it would be worth the effort to use this keyboard in my mind.
Thank you kindly for the information!