Melodeon.net Forums
Discussions => Other Free Reed Instruments => Topic started by: Rog on April 21, 2022, 04:26:25 PM
-
I’m restoring a little Hohner PA (a 'Vineta'…not a model I’ve seen before but identical to a Verdi I inside, and I’ve seen lots of those). The big bass reed pairs are H reeds, with Dural/aluminium reeds. The chord bass reeds are marked with a T and zinc (I think..it’s darker and heavier than the dural). The treble are all zinc but marked with a \ on the top right hand corner. I assume these are just another incarnation of Hohner reeds? Anyone like to comment? Theo?
-
I’ve seen those too Roger on diatonics. I think they are only found on instruments from the early 30s. I don’t know anything of their origin, but I can speculate that it was a time of rapid expansion for Hohner and perhaps they sub-contracted some reed making??
-
Thanks. Yes, that sounds right. Some (but not all) of the rivets have been hammered. But the tolerance of the tongue in the slot looks about the same as ordinary Hohner reeds, so I don’t think they are different apart from the markings.
-
The ones I’ve seen were thinner than typical H or T reeds.
-
As far as I can see nobody has commented about the left leaning mark ( \ ) on the top right corner of the reed. This is also common accordion reeds and I have understood this was to identify the outer reed. This is necessary since the tuning for interior/exterior reeds is different.
-
You are correct, BoxPlayer. The 'H' or 'T' usually found on Hohner reedplates plays the same role of identifying the outer side, in which case the slash is not required.