Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: melodona on September 08, 2022, 04:48:19 PM
-
Hello,
How would you go about this one? Epoxy? Aluminium is hard to solder...
Thanks for any tips.
Good day!
-
I do not think you can join the broken part with enough strength. You should remove the axle rod, remove the broken key and lever and you might be able to find a way to make a new aluminium rod and fix it to the key
-
Hello,
How would you go about this one? Epoxy? Aluminium is hard to solder...
Screwfix sell aluminium rod.
-
Getting the aluminium rod is the easy part. Choosing the right repair strategy is not so easy.
-
The other thing is it's a cassotto... got them two skates business going on. I was thinking that maybe by adding little "brace rods" on each side of it as solidifiers, I could cover more ground on it with epoxy...
-
If you want to try a repair like that than the strongest way to reinforce the join would be a tube that would slip over the rod. If you can’t find a tube then a piece of sheet aluminium rolled into a tube would work well, and might be easier to get into the correct position. You will need the epoxy as well of course
Another idea would be to use glass fibre or carbon fibre matting wrapped round the break and coated in resin.
-
Thank you all for the responses.
-
eBay can be a good source of parts e,g, Theo's idea of a tube, which I think is probably your best bet - you can buy all sorts of brass tubing and would be able to crimp it a bit, as well as glue it. But cassotto boxes can be a right royal PITA, so good luck.
See
https://www.ebay.co.uk/itm/Brass-tube-Thin-wall-for-model-making-craft-work-in-metric-size-diameters-/161737898544?mkcid=16&mkevt=1&_trksid=p2349624.m46890.l49286&mkrid=710-127635-2958-0