Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Martyn Hunter-Wyatt on October 17, 2022, 08:48:29 PM

Title: Replacing corner diamonds
Post by: Martyn Hunter-Wyatt on October 17, 2022, 08:48:29 PM
Is there a video on how to replace corner diamonds? I’ve done one but it turned out to be a mission. It will be satisfactory but I think it could be better. I found it very difficult to get the folds in the leather to form where I wanted them. Any tips from someone with more experience would be most welcome.
I saw a comment from Theo about replacing bellows if there were a lot of holes, but I only have the odd one or two to do.
Title: Re: Replacing corner diamonds
Post by: Theo on October 17, 2022, 10:36:02 PM
Much easier to patch the damaged gussets from the inside.  You need very thin leather, and the result is always a bit less flexible than the original.  Replacing the whole diamond from the outside does involve peeling back the edging tape and the lining paper and when I’ve tried that I’ve never been happy with the look of it.
Title: Re: Replacing corner diamonds
Post by: Martyn Hunter-Wyatt on October 18, 2022, 09:00:43 AM
Thanks Theo, I’ll try the next one from the inside.
SimplePortal 2.3.5 © 2008-2012, SimplePortal