Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Squeaky Pete on November 16, 2022, 08:48:07 PM

Title: Hohner glued in reedblocks - which glue?
Post by: Squeaky Pete on November 16, 2022, 08:48:07 PM
I'm tidying up a Hohner 4 stop and when taking out the reeds I noticed the glued in blocks seemed loose. Where they touch each other it all seems fine but there is definite movement allowing the blocks to flex, especially the one with the L reeds .
The brown glue seems to have gone brittle. I have seen this on the joint around the Fondo and have just run PVA into the joins to seal any airleaks. But I suspect that might not be appropriate here.
It's a silver ended 17 fold bellows model with plastic keyboard so I presume 50s or 60s?
So what glue do I use?
Incidentally the reeds are all rusted next to the valve glue.
Title: Re: Hohner glued in reedblocks - which glue?
Post by: Theo on November 16, 2022, 08:53:05 PM
PVA doesn't bond effectively to hide glue or other gelatin glues.  If you want to use modern glues then sand off the old glue down to a fresh clean wood surface.  Or do a less extensive clean down and use a traditional glue.  I've found fish glue to be handy for occasional use in this sort of situation because it is supplied as a liquid so there is no need for a glue pot.  It also gives a longer open time than hot glue which I often find useful.
Title: Re: Hohner glued in reedblocks - which glue?
Post by: Squeaky Pete on November 16, 2022, 09:03:59 PM
I have no fish glue, but plenty pearl glue, so hot glue it is ,
I'll put some to soak before bed.
SimplePortal 2.3.5 © 2008-2012, SimplePortal