Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Peadar on December 25, 2022, 10:43:07 PM

Title: 1040 TUNING- GOT TO START SOMEWHERE
Post by: Peadar on December 25, 2022, 10:43:07 PM
After four years finally mapped the tuning on my 1040.
It is in need of some, ahem, *minor* adjustments. :|bl :|bl :|bl

What is a sensible target range to aim for, on the basis of even temperament - one reed bank at 0 and the other at +12 ?

And which would usually be the zero reed bank?

Are these collectively so far off that I would be better taking them all off and doing them individually on the tuning table?

Can anyone give an indication in cents as to what might be a likely variance between a reed on tuning table and in the box (recognising that this isn't an exact science)

Happy Christmas Everybody!

Title: Re: 1040 TUNING- GOT TO START SOMEWHERE
Post by: boxcall on December 26, 2022, 01:31:28 AM
Hi Peadar,
Here’s a target I used ( scavenged from a video posted on tuning) sorry!
I just pulled the target numbers / + plus cent  offsets from it, hopefully right. I have just recently tuned a box to this and it sounds good to me. Although a note the 7 button pull A note sounds off, I’ll be tweaking it more.
I did the bank closest to keyboard plus cents ( chart provided) and the other to pitch.
Title: Re: 1040 TUNING- GOT TO START SOMEWHERE
Post by: Peadar on December 26, 2022, 07:44:03 AM
Thanks Boxcall,
That's a great starting point. :D

The other question is still open- is it better to take the reeds out of the box or retune with them in it?
Title: Re: 1040 TUNING- GOT TO START SOMEWHERE
Post by: Theo on December 26, 2022, 02:08:21 PM
It’s usually best with 1040 to take all the reeds out so you can replace the old wax.  If the reeds need cleaning or the valves aren’t perfect you can deal with that too.
If you check the reeds for pitch on your tuning rig you can adjust any that are badly out of tune. On my tuning table I usually do this pre-tuning to get the pitch approximation 10cents sharp of the target pitch.  Tuning tables do vary so it’s worth testing a few reeds on the table then compare with the pitch when they are waxed into the instrument. Final tuning is best done in the instrument once valving and waxing is completed.
SimplePortal 2.3.5 © 2008-2012, SimplePortal