Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Willem Feltkamp on January 29, 2023, 01:25:34 PM
-
Hi all,
I've recently acquired a wonderful two voice Hohner club box. I've posted here about my endeavour to convert a club CF to GC, but now I've found a GC club; someone simply put GC blocks inside. Where did he get these? could they be from an Erica or other type? Are these interchangable among models?
My models is squarish, with metal on the rounded corners and a purplish finish. it's simply called Hohner club II. Is this pre-war?
This new box plays with very little effort and it has a wonderful mellow sound.
But: I intended to play balfolk along with other musicians, however it turns out the instrument is tuned flat.
The lowest of the two voices is tuned from around -15 cents (occasionally -20) , on average -13 cents below A440 reference pitch.
the upper voice ranges from -3 to +9 cents.
Do any of you have experience in succesfully tuning to concert pitch instruments with such deviations?
I've done tests on scrap reeds which indicate I could do this without ruining the sound, but I'd hate to damage this box so I'd rather be sure.
-
In my limited experience, I'd suggest that it would be a simple, if time taking, task. Just get started and be careful!
-
It's mainly the amount of tuning I'm a bit worried about.
So far I've mainly have had to tune down instruments that were tuned too high.
Tuning up there's a risk of taking away too much material from the top. I've ruined reeds that way in the past.
-
This seems to be an instrument that is tuned to the old German standard of A=435Hz. I’ve tuned many such boxes up to concert pitch with no impact on reed response or tone. It’s best done with the reeds off the blocks, then final tuning done on the blocks with the blocks in situ.
-
Theo, thanks for the advice. I'm reassured the tuning will not harm the instrument.