Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: BamaBino on February 12, 2023, 03:53:10 AM
-
Greetings,
Can the Bass Configuration on a B/C box be easily changed, such as from
McComiskey to Burke?
Thanks
-
Easily is relative, but yes, a technician can swap reeds out or retune them, or use a combination of the two methods.
If you're asking if it's a home project, I would say it is not easy unless you are experienced with modifying reeds and reedblocks, tuning, and rewaxing.
-
Gonk,
Thanks for the quick reply!
I'm sure "swapping reeds or retuning them" is not an easy task.
I am ignorant about what goes on onside the box.
I wondered if the "linkages" could be moved.
Cheers
Easily is relative, but yes, a technician can swap reeds out or retune them, or use a combination of the two methods.
If you're asking if it's a home project, I would say it is not easy unless you are experienced with modifying reeds and reedblocks, tuning, and rewaxing.
-
I wondered if the "linkages" could be moved.
The linkages? I'm not sure what you mean. The linkages from the bass buttons to the bass pallets should be left alone unless you intend a major modification, like swapping in the bass mechanism from another instrument.
If you mean that you want to swap the locations of two chord buttons (without replacing either), that would just require swapping the reedplate locations.
-
I believe these would be the changes required:
(http://)
-
The ones under the blue boxes would not change
(http://)
-
I see what you're thinking. But, each one of those pairs is a single reedplate, so they can't be separated that way, convenient as it would be. If I were converting a box to Burke, and I could source a good reed match, my preference would be to use unisonoric reeds (such as found in piano accordions) for the D and G, and weight the D/F to become a C/F.
-
I see what you're thinking. But, each one of those pairs is a single reedplate, so they can't be separated that way, convenient as it would be. If I were converting a box to Burke, and I could source a good reed match, my preference would be to use unisonoric reeds (such as found in piano accordions) for the D and G, and weight the D/F to become a C/F.
Thank you for this reply.
That makes sense.
-
I see what you're thinking. But, each one of those pairs is a single reedplate, so they can't be separated that way, convenient as it would be. If I were converting a box to Burke, and I could source a good reed match, my preference would be to use unisonoric reeds (such as found in piano accordions) for the D and G, and weight the D/F to become a C/F.
Can the existing D and G bass/chords be reconfigured to be unisonoric ?
Thanks
-
Can the existing D and G bass/chords be reconfigured to be unisonoric ?
Thanks
You could hack the reeds about, but it’s much easier, quicker and probably no more expensive for a good accordion technician to replace the reeds. The result will probably play better after replacing reeds.