Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: John Krienitz on November 27, 2023, 01:00:24 PM

Title: Paolo Soprani coupler buttons question
Post by: John Krienitz on November 27, 2023, 01:00:24 PM
Hello, all.  I have a Paolo Soprani from the 50’s (I believe).  It was previously a G/C with stepped keyboard.  John Nolan expertly converted the reeds to C#/D, and I converted to a flat keyboard.  (Thank you, Lars, for the advice). 
There is nothing on the back side of the coupler buttons to engage with the coupler mechanism.  The mechanism works fine, when switched by hand, but the grille has to be off to do this, of course.  Can someone send a photo of the back side of their coupler buttons, so I can see just what needs to be fabricated?  I’m guessing it may just be a simple little arm, but I would love your help, if possible.   
Many thanks,
Damon O’Gan (John Krienitz is the name of the man who made my first fiddle - Kansas, 1912 - I stupidly used it as my username years ago)
Austin, TX
Title: Re: Paolo Soprani coupler buttons question
Post by: odonovanchris on November 27, 2023, 01:26:48 PM
There are 2 little brass prongs that engage with the coupler mechanism and are screwed into the wood on the back of the coupler switches.
These are easy to make with a tin snips and brass sheet.
Title: Re: Paolo Soprani coupler buttons question
Post by: John Krienitz on November 27, 2023, 01:34:42 PM
Thank you so much for the quick and very helpful reply!
I appreciate you, and this entire forum, so dang much. 
Best,
Damon
Title: Re: Paolo Soprani coupler buttons question
Post by: hickory-wind on November 27, 2023, 01:35:22 PM
Here are some photos of a pepperpot. It is GC with stepped keyboard. Only one picture inside but it shows that each prong bracket (L shaped) is held with two screws.

Scott
Title: Re: Paolo Soprani coupler buttons question
Post by: John Krienitz on November 27, 2023, 01:41:38 PM
Super, thanks a million!
SimplePortal 2.3.5 © 2008-2012, SimplePortal