Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: mselic on December 18, 2023, 03:45:15 PM
-
Upon opening this instrument I discovered that there is quite a bit of mold on the bellows and reedblocks, etc. The wood can be sanded down and cleaned up (outdoors, of course!) but I'm wondering if there is anything I can do to remove the mold on the inside of the bellows? My first thought was to wipe it down with a mild solution of water and vinegar, then hang up to dry. I asked this question on a fb forum as well, and answers varied from wiping it down with various products to simply throwing the entire instrument away. It belongs to someone who would like it restored as it has some sentimental value to their family and they would like it playable again. A full reed overhaul would be needed, but I don't want to throw good money after bad if it's beyond salvation. Mechanically, the instrument is good and the reeds are perfectly serviceable. It has a lovely tone and I feel it would be a shame to throw it away if there's any chance at keeping it going. Any input would be appreciated.
-
I’m not convinced that it’s mold.
It looks more like foxing, a deterioration found in old books, which is also caused by high humidity. Lots of advice online. Just one example here. https://pennbookcenter.com/what-is-foxing-on-books/
-
If it is mould:
For wood, assuming you don't intend to glue anything to that surface - Personally I'd wipe down with plenty of IPA and then put a coat of shellac over it.
Can't guarantee that it will work, but I've done it in the past and did not have issues with mould returning. My thoughts are that IPA kills the mould (does it though?..) and shellac seals the wooden surface.
For bellows, I've used the following method about 3-4 years ago inside & outside of the bellows and, so far, haven't noticed any long-term deterioration of the card (so far...do this at your own risk):
A 50-50 mix of IPA and vinegar (shaken, not stirred), get a dishwashing sponge, get it damp (not dripping wet) with the mix and rub the folds, getting them moist. Having a wee jig to keep the bellows open really helps. Then leave the bellows to dry, ideally outdoors on a windy day. This also does wonders to remove any unwanted smells (but it does leave a hint of vinegar smell that might take a few months to go away.
I have been told that, in theory, getting vinegar into cardboard might make it deteriorate a lot faster over the years...But to be fair, the alternative is to chuck the bellows and buy new ones anyway.
-
I’m not convinced that it’s mold.
It looks more like foxing, a deterioration found in old books, which is also caused by high humidity. Lots of advice online. Just one example here. https://pennbookcenter.com/what-is-foxing-on-books/
Yes! This is exactly what it is!
-
Also, check in with Gonk, who addressed a similar (or entirely different?) problem on one of my boxes.
-
IPA? I imagined that you Morrising chaps would rather drink that. (Unless I'm barking up the wrong acronym?)
-
IPA? I imagined that you Morrising chaps would rather drink that. (Unless I'm barking up the wrong acronym?)
Iso Propyl Alcohol, best with a dash of orange I find 8)
-
Thank you Mr Bailey. Another mystery solved for the forum eejit!
I recently bought an oldish thing with what looked like a load of snow in the bellows! At first, I wondered if it may have been used for smuggling some sort of illegal substance, so I didn't taste it. I eventually got around to cleaning it out with a stiff paintbrush and the good old vacuum. Worked a treat! (I'll keep an eye on it while it's in my care.)