Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Christian E on February 26, 2024, 07:47:02 AM
-
Well, the MADness has begun. I have a second box.
I bought it off a charity site for very little, key unknown. A "Rigoletto - Made In Germany US Zone" one row, two stop, melodeon. It turns out that it's in "D", which is handy.
A couple of the reeds are rattling, and scratchy sounding, and I'm not sure yet what to do about that, but I will learn! I will fix it!
It overall sounds pretty good? The bellows may leak some but it's so small that doesn't seem to make a huge difference? But the main leak seems to be from a weak spring on the air button, and a poor seal on the same.
It's welcome any advice from the experienced people here. I figured this one was a good place to start, and as it came from Arizona, it's not musty or damaged by humidity.
I'll post more as I go further along, but here's a picture of the new baby melodeon. I think it's cute.
-
Congrats.
Something this old will probably need to be re-valved, which might remove unwanted noises when playing.
If you hear a reed clipping the sides of its slot, then you can try:
1) If it's misaligned, very carefully, without damaging the reed tongue, turn it in its slot. If the reed turns easily, a kiss with a tack hammer on the rivet will tighten it, but if you have never done riveting before, I recommend practicing on a scrap piece first, as hitting the rivet too much can make things a lot worse.
2) very carefully running a stanley blade along the slot's side where the reed is clipping (just scrape the top corner of the slot, no need to scrape the full plate thickness) - this will scrape off a tiny amount of aluminium and the reed will be free again. We're talking about removing half a hair's thickness, not 1-2mm >:E
Have fun!
-
Thanks, I somehow missed your reply. I appreciate it!
-
One year later, you still have it?
I just got one, two stops, in D as well, in near perfect condition, like it was never played before.
I had a few notes sounding when pushing on the bellows. I slightly bent the rods so the pallets sat perfectly but if i push hard, i still get sound... I think the springs are weak.
I'll open it open later this week, a few notes need to be tuned.
This thing is so small, I will need some time to adapt to it. On the bright side I think I'll pack it in my carry-on next time I travel as I will still have plenty of room left for other stuff!
-
Side by side with my two row Hohner. ;)