Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Sebastian Trudgian on April 16, 2024, 03:43:12 PM

Title: Making more holes in a melodeon strap
Post by: Sebastian Trudgian on April 16, 2024, 03:43:12 PM
This is probably a really obvious question.

I'm still in love with my new melodeon (Serenelli Deluxe 273), but if I put the back straps (and straps attaching them to the melodeon) on the smallest settings, they're still a little big on me.

I like them though (leather on a soft material backing) and would ideally like to add more holes (there seems plenty of space) to be able to make them smaller (photo attached if logged in)

Has anyone done this professionally before and know the best practice?

On a belt I'd just carefully drill through with a sharp drill (or use an awl), but I want to do it properly here and not damage the straps, so wondering how it's done properly (possibly still with a drill?)

Thanks for your time.
Title: Re: Making more holes in a melodeon strap
Post by: Lester on April 16, 2024, 03:45:31 PM
You may not thought of this but IO use a drill  8)
Title: Re: Making more holes in a melodeon strap
Post by: Theo on April 16, 2024, 03:49:31 PM
A hole punch will make a cleaner hole than a drill.  If you only have a drill available then start by clamping the strap tightly between two pieces of scrap wood then drill through the wood into the strap. This will stop the leather and backing from tearing where the drill enters and leaves the strap
Title: Re: Making more holes in a melodeon strap
Post by: Sebastian Trudgian on April 16, 2024, 09:38:52 PM
Ooh that’s a good tip thanks.

I’ll give it a go by drilling with the wood clamping method, thanks.
Title: Re: Making more holes in a melodeon strap
Post by: Dick Rees on April 16, 2024, 10:01:00 PM
Got a Swiss Army knife?
Title: Re: Making more holes in a melodeon strap
Post by: mChavez on April 16, 2024, 10:03:56 PM
A round (or oval) punch will not create tears & stress points in the strap and is less likely to lead to problems.
Other methods: Drill/awl/knife/.22LR will.

A set of cheap punches will work well, cost peanuts and will come in handy in the future.

If you want it perfectly centered, mark a dot with an awl (use a ruler), then lightly press the punch against the leather, trying to center the circle around the dot. You can lift the punch and press it a bit harder if your original attempt was off-center. Each attempt will leave an impression, but it will be getting deeper, so very easy to re-locate the punch.
Once you are happy with the hole placement, only then whack it with a hammer (make sure there's some sacrificial plastic or wood under the strap. Don't do it on your kneecap  >:E
Title: Re: Making more holes in a melodeon strap
Post by: Andy Next Tune on April 17, 2024, 09:48:44 AM
You can often add an extra hole or two at the end of the strap that attaches to the instrument. This short length of strap is not usually padded and so easier to punch/drill through.
Title: Re: Making more holes in a melodeon strap
Post by: Sebastian Trudgian on April 22, 2024, 06:04:07 PM
Thankyou everyone, I went with the clamp/drill option and it worked fine (the bits that attach to the bottom had no more space on mine for holes)
SimplePortal 2.3.5 © 2008-2012, SimplePortal