Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: CajunBoxPlayer on February 10, 2008, 08:18:33 PM
-
What would you say would be the best way to remove rust spots on reeds?
-
If its just a few small spots leave them as they are. If the tuning sounds ok then leave the rust where it is.
If its more then get one of these polishing blocks (http://www.maplin.co.uk/Module.aspx?C=SO&U=strat320&T=sitenew&ModuleNo=2109) from an electronics store. Fine wet and dry paper works too. Use something thin slid under the reed to provide support. If the back of the reed is rusty then then use the blade of a fine screwdriver to scrape the rust off. Expect that retuning will be needed after the reed cleaning.