Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Arnold on August 19, 2024, 06:12:15 PM
-
Hi, I have a troublesome B3 note on a HA113C, middle of the L bank… it makes a rattly buzz when played gently, which disappears under increased pressure. Any ideas what is most likely to be causing this? The reed is in a troublesome position and the wax is old, so I’d like to remedy it in the block if possible… Thanks
-
Hi, I have a troublesome B3 note on a HA113C, middle of the L bank… it makes a rattly buzz when played gently, which disappears under increased pressure. Any ideas what is most likely to be causing this? The reed is in a troublesome position and the wax is old, so I’d like to remedy it in the block if possible… Thanks
The bold bit may well give you a clue. A slightly loose reed may well buzz when played with low pressure, extra pressure may help seat it better. Please note the copious use of MAY in my reply
-
It’s typical symptoms of a valve that’s not closing fully. The tip of the valve may be lifted or the valve may be arched so the centre of the valve is not lying flat. In either case just replace the valve beside the reed. If it’s a push note it’s the one on the outside of the block, pull not inside the reed chamber.
-
I've got a similar issue on my lowest note in one of my boxes. I thought it was plastic valve buzzing, but when I replaced it with vileda, exactly the same buzz is still there. Tried bending the mylar springs to make the valve stiffer, but had no luck. I've inspected the valves, plates & chamber for anything odd - nope, all is fine.
I'll try leather next. Could it be valve stiffness after all? Just needs a strong steel spring?
-
Thanks for the responses. I have a strong feeling now that it’s the valve thing, having dealt with rattling reed plates in old wax previously… And that means removing the plate to get to the valve :Ph, and then a likely domino effect of aarghhh, as crumbly wax gets everywhere… There was no need for Hohner to mount the L bank facing the M+ bank was there?!.. Might leave it be…
-
If you're really, really careful, you can take off the keyboard, then the pallet mechanism and replace the valve through the sound hole.
Tricky, very tricky, but possible.
-
Thanks Pete, that would be the way to go about it I think… I’ve a tendency to play very quietly when practicing and so I do notice these little annoying things!..
-
m Chavez, that sort of problem on the lowest note on push can be from the tee tongue striking the case or the bellows frame, only if it’s the outside row of course.