Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Aaron Wildman on August 27, 2024, 02:33:02 PM
-
My hohner has a mix of buttons on the treble side. There seem to be two different crowns. Since it is c#/d, I would like to at least have the D row with the same style of crown. This would mean swapping 5 or 6 buttons between levers.
If I use the soldering iron method for removal, will the buttons be able to reinstall without problems? Any suggestions otherwise? I don't want to pay $4 per button to replace.
-
I've recently been swapping a set of MOP buttons from an old 3 voice club to fit onto my latest 1 row. I just knocked them off using a vice, and pressed them back on with a pair of Vise Grips and some cloth so as not to damage the top surface.
Worked a treat, and no heat involved.
-
Don't know about re-using, but for removing & installing I was not happy with the soldering iron.
Instead, a dremel versa-flame & a home-made brass button shield seem to be working a lot better.
(https://i.ibb.co/xDdzZ77/PXL-20240823-103829623.jpg)
(https://i.ibb.co/w4Y5h6S/PXL-20240823-103751007.jpg)
-
No heat is required. Support below the button on both sides (such as a vice mentioned by Winston). Snug the vice up to remove play but not grip the lever, then a sharp tap on the top side of the lever should remove it. Easiest if the mechanism is completely dismantled.
If you do resort to heat and the button no longer holds then you may need to use a spot of epoxy.
-
Please don't make me disassemble the mechanism. I don't want to go down the rabbit hole of updating springs etc, and once it is apart, I will feel obligated.
Siince there are some buttons on the inner row that have to be removed, I wil have to get creative. Perhaps a slot sawed into the end of a dowel (so it slips over the lever but still supports the button) or something.
Thanks for the direction, gents.