Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Arnold on September 02, 2024, 09:26:39 PM
-
I just took a 1cm square stick of wood and put it into the gap between the fingerboard and pallet levers. I stuck a bit of felt to the side of the wood pressed against the levers to act as a buffer, and this also helps to hold the stick in place. I needed to make the wood slightly thinker to limit the travel further, so I added a layer of masking tape. As a precaution, I put a length of dowel across the inside of the grille to block the stick from potentially falling out. Seems to work a treat!
-
I believe that's how the button travel on my Pressedwood is limited, the Pokerwork and the Erica I had at different points were limited with felt in replacement wooden keyboards that Pete used to sell... the odd thing is that I don't feel it is a necessary mod on either of my HA114s although I did with those other boxes.
It's good that there's a simple and effective option when desired though.
-
I just put felt inside the keyboard and managed to squeeze it past the buttons. Worked better on my HA114 with a wooden keyboard - trickier on the plastic one for some reason.
-
All down to personal preference of course, but I like to limit the button to flush with the surface, and felt alone wouldn’t do this. I’ve fiddled around with getting bits of wood under the leavers before but this is far easier and more adjustable. Playing keyboard instruments previously I find it essential to good response, and it also limits pallet slap.
-
Mine is very nearly flush with the top surface of the keyboard. The trick is use as little felt as needed in order to just catch the bottom of the button lever. But yes, it's quite finnicky to get right. I think the shape of the underside of the button levers also changed slightly over the years making it harder to do what I did with later models.
-
Ah, yes I see. I’ve no experience with wooden keyboard on this model but the plastic one was divided up inside… Another unintended advantage I noticed is that having the stick in the gap prevents the grille from being bashed in, as you see with many an HA114!..
-
Just a thought: with the stop stick acting on the pallet levers, a benefit is that one could tweak the button stop height with the usual Hohner button height adjustment procedure. The corresponding downside: a hard player may over time push in the buttons so that they no longer stop level with the keyboard.
-
I thought about that, but since force is applied so close to the pivot, the amount needed to adjust the button height would be quite high I should think. If this is a problem, then I’d expect button height to reduce over time (and more so on most used buttons 3-8), and then I’d have to consider one of the alternatives!.. I think the layer of felt might help in this regard…
*think I got my physics a bit muddled there as the buttons are the opposite side of the pivot to stick, but anyway, I’m fairly confident that with normal playing this won’t be an issue…