Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: SqueEzold on January 06, 2025, 01:50:32 PM

Title: Mixing Hohner Reeds (entire row)
Post by: SqueEzold on January 06, 2025, 01:50:32 PM
Has anyone tried building up a hohner with one entire reed block made up of H zinc plate reeds and the other block entirely T stamped Aluminum reeds? I’m wondering if the difference in tone is noticeable or if it is negligible. I have multiple sets of each, but would need to mix them on a few projects. This would likely be a semitone box for whatever that is worth.
Title: Re: Mixing Hohner Reeds (entire row)
Post by: Pat McInnis on January 06, 2025, 07:43:00 PM
I have a C#D built up like that and for me anyways, it seems negligible. Especially since you are only playing primarily on the one row and just dipping into the C# row for reversals and lesser used notes. Others may disagree. They usually do. >:E 
Title: Re: Mixing Hohner Reeds (entire row)
Post by: mselic on January 06, 2025, 08:18:17 PM
In a lot of older Hohners you’ll actually see a mix of H and T-stamped reeds, as well as a mix of zinc and aluminum plates, all in the same instrument, straight from factory.  In each case, I’ve been unable to determine any difference in tone. I’d say you’d be fine to mix and match as needed.
Title: Re: Mixing Hohner Reeds (entire row)
Post by: Theo on January 06, 2025, 08:21:30 PM
Most two row boxes with all matching reeds have tonal differences between the rows so the slight difference between Hohner reeds  on zinc or aluminium plates will not be a problem
Title: Re: Mixing Hohner Reeds (entire row)
Post by: SqueEzold on January 06, 2025, 11:23:08 PM
Great, thanks for the responses! I’ll try and post the results here if I remember.
SimplePortal 2.3.5 © 2008-2012, SimplePortal