Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Helena Handcart on May 09, 2025, 06:36:05 PM
-
As the title says, one of the bellows pins on beloved Nuage has become loose, so loose in fact that my husband found it on the kitchen floor. Any tips for re-fitting the pin? The hole doesn't look to be enlarged in anyway but the pin falls straight out if I pop it back in.
The Nuage has six bellow pins rather than the standard 4 so it's not strictly structurally necessary but there's air escaping which is sub-optimal and a little annoying.
-
Easy stop-gap fix is to put a little reedwax on the pin before popping it back in For a more long term fix, what I typically do is just fill the pins holes with epoxy (both bellows frame end and casework end) and drill them out again with the correct sized bit. You’re not drilling any wood, just into the epoxy. I find it works better than filling the holes with wood and wood glue, and is easier and quicker.
-
There is a non-invasive method that I've not tried yet, but is very simple. get some water into the hole, maybe with an eyedropper, our syringe act, allow the water to soak in which will expand the wood. When it dries it won't go completely back to its original enlarged size.
Wax on pins does help, but it might compromise the later effectiveness of a method that uses glue.
Another method that I have used successfully uses superglue. For this to work the surface of the shaft of the pin must be absolutely smooth.
First separate the bellows from the end casing. Insert the pin roughly half way then add thin superglue from both sides so that you are gluing the pin in place. Leave long enough for the glue to cure thoroughly, I usually leave overnight. When cured you need to break the bond between the pin and the glue by either twisting to firmly with pliers, or give the end of the pin a sharp tap with a hammer. I usually use the twist.
It seems drastic but it does work very well.
If you use any method the involves filling and drilling it's worth looking for a slightly undersize drill, eg 2.4mm for the usual 2.5mm pin.
-
I used to give them a little tap with a hammer to induce a minuscule bend. You need to be very light about it but it does make them grip again without doing anything to the wood. Subsequently you have to be very clear as to which pin came out of which hole. And then put it back in the same one!
I expect to be told that this was a pretty idiotic thing to do, but it worked for me 30 years ago.
-
I used to give them a little tap with a hammer to induce a minuscule bend. You need to be very light about it but it does make them grip again without doing anything to the wood. Subsequently you have to be very clear as to which pin came out of which hole. And then put it back in the same one!
I expect to be told that this was a pretty idiotic thing to do, but it worked for me 30 years ago.
Yes it works, but it enlarges the hole, so make the underlying problem worse.
-
Having tried wax many times, i find it's not a great fix and doesn't solve the problem. Next time however i will use Theo's fix. Sounds marvellous. On a few occasions I have resorted to putting a very slight bend in the pin, as per Chris (it's not that daft), but I use two pairs of pliers. I'm not convinced it enlarges the hole though. It just makes the pin fit more tightly, and it's very quick. Sometimes swapping the pins around works too, esp on my Nuage, where they don't all fit in the same way. One of the other pins might fit better. This happens a lot on Italian PAs…so when I get a loose pin I swap them around (or swap a particularly tight one) and this works in most cases.
-
If the water method doesn't work, a sliver of wood in the hole before re-inserting the pin worked for me, old fashioned matchstick or a cocktail stick will do the trick ;D