Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Willem Feltkamp on February 23, 2026, 11:28:37 AM
-
I found a video of a chap who tells us where to file a reed depending on the curve/profile of the reed.
This is new stuff to me. What do you think about what he says?
have a look at counter 1.22:20
https://www.youtube.com/watch?v=ZveDaMwS2kQ&t=4589s (https://www.youtube.com/watch?v=ZveDaMwS2kQ&t=4589s)
-
He has a good understanding of the process of adjusting the pitch. One comment I would make is that the reed he starts with appears to have the tip loaded with solder. I keep an old file for solder, and avoid using a nice new clean file because the solder will get stuck in the teeth of the file.
-
so Theo, is this avoiding to touch a certain area of the reed something you do too when tuning? What I do is to tune down smaller reeds I make a scratch lengtwise in the centre of the reed, probably along all of the lower half. On bigger reeds or bass reeds I might try to file away an even surface across the width of the reed around 1/3 from the base.