Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Ross Dubois on July 19, 2026, 07:52:55 PM

Title: Paint used on Hohner wooden keyboards
Post by: Ross Dubois on July 19, 2026, 07:52:55 PM
Hey folks,

Took receipt of a HA-113 and someone nearly 70 years ago put masking tape on the wooden keyboard. That masking tape bonded to the paint of the keyboard and despite my best, most careful methods and attempts to remove it, the paint just did not come out unscathed.

I'm considering just sanding and repainting. What kind of paint would be appropriate for this job? Id prefer something a bit more durable than this.

It's a shame, it was in near mint condition otherwise but what can you do.
Title: Re: Paint used on Hohner wooden keyboards
Post by: Grumpy on July 20, 2026, 08:47:02 PM
Had very good results in the past on pokerwork keyboards using Hammerite  Black gloss. A little expensive for the couple of brush fulls needed but has always given a long lasting tough finish, looks good and is very quick drying. Regards Chris D
Title: Re: Paint used on Hohner wooden keyboards
Post by: Theo on July 20, 2026, 09:45:44 PM
I’ve stripped and repainted a few Hohner keyboards.  Preparation is everything.  I chemically strip the old paint.  Carefully sand the wood finishing with 400 grit.  Then prime and spray several coats of black aerosol car paint from Halfords. I prefer the semi-matt finish.
Title: Re: Paint used on Hohner wooden keyboards
Post by: Fionn on July 20, 2026, 10:21:06 PM
If you want a hardwearing finish without much shine to it, Sadolin Classic in black might be an option?

It's not a paint, it's a dense wood stain that gives a fully opaque finish. Doesn't peel, doesn't tend to leave brush marks, and shows some of the surface grain (which can make it look less "new" than modern paints).

Drying time is slow, though. You'd probably need at least two coats with 24 hours between and then ideally leave it aside for another day to cure fully.
Title: Re: Paint used on Hohner wooden keyboards
Post by: chris hall on July 20, 2026, 10:36:15 PM
ive used liberon black wood dye then liberon finishing oil.......as recomended by rees wesson......takes some time...lots of coats with sanding between coats but excellent finish
SimplePortal 2.3.5 © 2008-2012, SimplePortal