Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: David J on August 23, 2010, 01:55:24 PM

Title: Removing rusted bellows pins
Post by: David J on August 23, 2010, 01:55:24 PM
I know that this topic has been covered in various places before and I've had a good read around various postings.

I've just acquired an old Hohner Tango I PA and before deciding whether it's worth restoring wanted to have a look inside, but have been unable to shift a single pin. The pliers which work OK on my melodeons just slip off, so I have ordered some end nipper pliers today. I seem to remember from the Mendlesham workshop last year that Rees had doctored his with a little notch on either side to create a better grip on the pin head.

The Hohner pins have a round head with a little collar underneath.

I think that heating the pins with a soldering iron is one technique, but is there anything else that can be suggested? I don't think levering them is a good idea as it would be easy to crack the celluloid.

Any ideas gratefully received.
Title: Re: Removing rusted bellows pins
Post by: Lester on August 23, 2010, 02:01:54 PM
The answer probably can be found here:

http://forum.melodeon.net/index.php/topic,2600.0.htm (http://forum.melodeon.net/index.php/topic,2600.0.htm)l
Title: Re: Removing rusted bellows pins
Post by: Ebor_fiddler on August 24, 2010, 05:39:45 PM
I use one of those tools for removing nails from floorboards. It just needs a wiggle to get it into position for lifting (Yes! - tacklifters! That's what they are called!) It seems to produce no observable damage and, even if you buy a new good one, is relatively inexpensive.  (:)
SimplePortal 2.3.5 © 2008-2012, SimplePortal