Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: mikesamwild on May 17, 2008, 11:27:45 AM
-
I am impressed at the way members will share tricks of the trade and am intrigued by the tools folk use. I have found tools from a variety of trades and professions like dentists, beauticians and jewellers, modelmakers,bookbinders etc
I have never come across a diamond file as thin as a feeler gauge to remove corroded material from the slot in a reed plate. Any ideas apart from fine emery paper?
Also what is the best glue for sticking leather reeds back onto metal plates. PVA and Copidex don't do it very well. What did the old boys use the old bone and collagen gluepot that was always steaming in the workshop?
-
"Old boys" used shellac to glue valves. . More recently in Cleckheaton they used Evostick .(OK for leather but not "plastic")
Doubt you will find anything thin enough to fit between plate and tongue with the latter at rest. Why not use a triangular Rat -tail as a scraper from underneath?
-
Thanks! I've just used a dentistsscraper and it does seem to peel off a layer from below. I'll try the rat tail file too
-
Better than a file for this job is a fine pointed scalpel blade. I file quickly gets clogged with the material you are removing.
For gluing valves i get good results with Bostik contact adhesive. It works well with plastic and with leather valves, and comes in a handy tube. It takes longer to dry with plastic valves, so after valving a batch of reeds its best to lay them aside for a few hours before mounting the reeds onto reedblocks. A few types of plastic valves are damaged by the solvents and quickly distort, so do a few valves first as a test.
-
A tip on Concertina net was a dentist's abrasive finishing strip - abrasive and flexible backed by metal For filing down adjacent fillings to lave a gap for flossing.
-
"Old boys" used shellac to glue valves.
Any reason why shellac is not commonly used these days? I've read advice given by the late Mr. Morse of the button box regarding shellac use as valve adhesive. Seems a bit more work than contact cement, but are there other reasons to avoid it?
-
I have tried some of the super glue species (cyanoacrylate) to attach leather valves. I prefer the thicker gel-like variety. Reed plate must be pretty clean and free of wax. A small dab or two on the valve, then press into place. The thicker glue allows you an interval to align the valve into exact position, then press firmly for about 10 seconds. Put aside a minute or two, it's fully set. After a year or so of playing, none of mine have fallen off (yet). It's no problem to peel off a valve glued down by this method, and the residual dried glue can easily be scraped off with a small scraper, no more difficult than the residue from standard adhesives.
If anyone knows a good reason not to use this type of adhesive, I would like to hear why. Regard this method as experimental (:)