Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: blafleur on November 21, 2010, 01:03:01 PM
-
I was recently informed of a glue I had never heard of before, fish glue. Kinda like liquid hide glue, only different. In researching it, it's most common use apparently is leather, and works well on metal. Was wondering if anyone uses it for reed valves, seems like a good match. Also easily reversible. Fairly quick drying, but good initial tack. I tried it on some and immediately sounded them and couldn't get them to dislodge even before drying.
-
I was recently informed of a glue I had never heard of before, fish glue. Kinda like liquid hide glue, only different. In researching it, it's most common use apparently is leather, and works well on metal. Was wondering if anyone uses it for reed valves, seems like a good match. Also easily reversible. Fairly quick drying, but good initial tack. I tried it on some and immediately sounded them and couldn't get them to dislodge even before drying.
I've never used fish glue but I've read that it is hygroscopic (unlike hide glue) and under humid conditions the joints can fail. So it might work well in Arizona but not so well in Louisiana........
I've used contact cement (Barge) which has fairly good initial tack and sticks to wood and plastic and leather very well and as far as I know is impervious to humidity. It is harder to clean off (for revalving) than the shellac type glues. This problem is helped by using it on a very small area for each valve.
-
I doubt that fish glue, though it may well work initially, would be satisfactory in the long term.
I am pretty sure it is water reversible and would be affected by humidity.
(I think it is the stuff used, before sellotape, on paper tape which was drawn through water to make it adhesive.)
-
It was also once in regular use in the theatre for attaching false facial hair. It used to stink something awful, but was easily removed with warm soapy water.
-
Hide glue seems to like humid conditions but it does NOT like low humidity. I had a complete lower bout on my fiddle come unglued when on tour in a hot dry situation. Fortunately I had a second fiddle with me at the time.
Nigel
-
It is harder to clean off (for revalving) than the shellac type glues.
When I get around to revalving my single row, it's clear that I'm going to have to remove some old glue. Didn't know what it was, but shellac seems possible - it's hard and dark coloured.
Is there a solvent or something to shift it, or will I just need to scrape it off?
(The valves re plastic (Mylar?) and I plan to use a contact adhesive, Bostik or Evostik, to re-attach them. )
-
I've been using my Dremel tool with a circular attachment like this
http://www.amazon.com/Dremel-512E-Finishing-Abrasive-2-Pack/dp/B000FBK43M/ref=combo_pack_i_13
I've been afraid to use solvents or anything else. It works quite well. I use a wire wheel attachment to remove old wax. They Make a wire wheel that is made for softer white metals like zinc etc. These don't damage the reeds or frames. This is my first attempt at reed work so take my recommendations with a grain of salt.
-
It is harder to clean off (for revalving) than the shellac type glues.
When I get around to revalving my single row, it's clear that I'm going to have to remove some old glue. Didn't know what it was, but shellac seems possible - it's hard and dark coloured.
Is there a solvent or something to shift it, or will I just need to scrape it off?
(The valves re plastic (Mylar?) and I plan to use a contact adhesive, Bostik or Evostik, to re-attach them. )
It scrapes off quite easily with a knife in my experience.